Your cart is empty.
Your cart is empty. Operation :
Long the up and down buttons of the instrument to enter the instrument settings.
P01:Backlight brightness,level 1 is the darkest,level 3 is the brightest.
P02:Mileage unit,0: KM;1: MILE.
P03:Voltage level: 24V,36V,48V.
P04:: 0,no sleep;other numbers are ,range: 1-60;unit minutes.
P05:Assist gear 1-9
P06:Wheel diameter: unit,inch;precision: 0.1.
P07:Number of speed magnets: range: 1-100.
P08:Speed limit: speed percentage range 0-100%,100 means speed 100%.
P09:Zero start,non-zero start setting,0: zero start;1: non-zero start.
P10:Drive mode setting 0: Power-assisted drive (the handle is invalid).1:Electric drive (drive through the handlebar,at this time the assist gear is invalid).2:Power-assisted drive and electric drive coexist at the same time.
P11:Assist sensitivity setting range: 1-24.
P12:Power-assisted start intensity setting range: 0-5.
P13:Power-assisted magnet type setting There are three types of 5,8,and 12 magnets,of which 5 and 8 are single-Hall power-assisted sensors.
Setting 12 is used for dual Hall assist sensors.
P14:No such function temporarily.
P15:No such function temporarily.
P16:ODO reset setting and hold the up button for 5 seconds ODO reset
type: waterproof plug
colour: black
Material: plastic
(5-pin waterproof jiet)
Note: The product is a five-pin connector, E10 is unable to communicate, and the communication protocol with the controller is wrong. The protocol of the instrument is lithium battery No. 2 protocol
Package Contents:
1 x LCD display (only for lithium battery protocol No. 2)
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Customer
Reviewed in the United States on October 10, 2024
It works like the original that it replaced
Recommended Products
