Your cart is empty.
Your cart is empty.Run up to a 32" tire while leveling the front of your truck with the rear, using Rough Country's Leveling Suspension Kit. A set of lower front strut mount extensions immediately offers increased ground clearance without the hassle of a long and drawn out installation process. Featuring 100% bolt-on installation and a unique design that allows fitment without the need to disassemble the strut, you're ready to get that killer look in no-time flat. Designed, tested and produced in Dyersburg, Tennessee USA by Rough Country. Estimated Install Time- 2-3 hours
BoJassim
Reviewed in the United States on July 12, 2024
Perfect for tahoe 2016 LTZ
Alpothewonderdog
Reviewed in the United States on June 28, 2024
This leveling kit worked perfectly on my 2018 Yukon Denali. I was at 36" to fenderwell in the front and 38" in the back. The kit fit perfectly and I had no issues with the installation. I now have the exact same wheel well height front and rear.
megan Carr
Reviewed in the United States on June 22, 2024
Bought this for my 2015 Yukon Denali with magnaride and it fit perfectly. Even gambled and bought a returned product for 16 dollars and the only thing it was missing was the original box. Every piece of hardware, equipment, and even the instructions were in a plastic bag. Couldn’t be happier with the product or the price.
P.Ronn
Reviewed in the United States on September 14, 2022
All hardware is included. Spacers are hard plastic but seem to work just fine. Final lift adjustment is about 2 inches. Two things to note during install: raise or jack the entire front, don't try to do each side independently. Also, loosen both driver and pass sway bar end links, makes for much easier manipulation of the suspension and struts to install the spacers. Hope that helps.
Adam Brock
Reviewed in the United States on October 15, 2022
Didn’t even take the tires off. Jack up front end. Pull bolt out of lower struts on both sides. Slide spacers in. Put new bolts in. Add spacers to mag ride sensors.
Craig
Reviewed in the United States on January 24, 2022
You do not need to remove or loosen all suspension parts as the directions state. Call a friend to help, remove the lower shock bolts, use a prybar to create space, and align the leveling blocks.
Joel H
Reviewed in the United States on January 9, 2020
Fit our 2015 Yukon Denali perfectly. Much easier to install than the typical ring type above the strut.
greg janus
Reviewed in the United States on August 11, 2019
Good
Recommended Products
