Your cart is empty.
Your cart is empty. Features：
Condition： 100% Brand New
Material： Billet Aluminum
Surface Finish： Red Anodized
Package Include： 1Pair Door Handle Sets,Bolts, No Instructions
Fitment： Fit For Can am Maverick X3 2017-2023 With Doors
（Works on Front and Rear Doors）
Do not fit Can-am With Door Bags！
It's a great idea to upgrade your UTV!
No more fumbling around for the strap to release the doors.
Just grab over edge of door and it’s right there at your finger tips, a little tug up is all it takes.
Getting out grab the top edge of door so it don’t blow open and its right there squeeze up with thumb and your out.
Additional parts required for Max rear door trim, (6 rivets not included).
A slight modification to the trim plastic is required to allow for the handle.
randy anderson
Reviewed in the United States on May 7, 2022
Good clean look and works great once installed, makes door opening the way it should have been from the factory. Some minor trimming of plastic panel need to make it work. There are no any instructions with it so if you look online you can find pics of how it's set up and just make yours look like that. I had mine on in about 35 min, 20 or 25 was on the first one cause I was going slow and making sure I didn't take more off the panel when trimming. Very much like the finished result, when you walk up to machine just place hand on front edge of the door and handle is perfectly placed to open, works great for opening door when it's loaded on the trailer, don't have to climb up on trailer and try to find that stupid little strap that came from the factory
joe ramos
Reviewed in the United States on August 25, 2021
Easy to assemble once you figure out what goes where 1st door took 40 min 2nd door to 10 min
c beil
Reviewed in the United States on January 19, 2021
What can-am should have done instead of pull straps. Easy to install and look great. A definite must.
Kenneth Knebel
Reviewed in the United States on June 10, 2020
I’m only giving this 4 stars because of the lack of instructions but with some patience and common sense you can figure it out. Make sure that you use red locktite on the bolts and as you can see in the middle picture this is all of the plastic that you need to cut. I did it with tin snips and I flipped the factory spring over for a better fit. They feel quite sturdy and are a great fit. It took about 45 minutes for the first handle and 20 minutes for the second.
Colorado Jim
Reviewed in the United States on May 24, 2020
As stated it does not work with interior door bags. The instructions are nonexistent.
Customer
Reviewed in the United States on October 31, 2020
Does not work very well Its built strong but u have to push the handle back down bec it sticks open
Curry logue
Reviewed in the United States on December 17, 2019
The aluminum handle is great the hardware is fairly sloppy in my opinion. Bolts keep working loose
Peggy M.
Reviewed in the United States on October 27, 2019
You get what is listed but once you open the package you realize it uses springs that are not included. Now I must buy an assorted spring kit to fix. Also where the arm attaches to the handle you must put your own small washer there to allow free movement. Use loc-tite so you don't tighten them too much preventing free movement.
Recommended Products
$124.88
$ 52 .99 $52.99