Your cart is empty.
Your cart is empty.Raising your ProTaper bars on a Polaris sled used to be a challenge - until now. This kit includes a 2" riser block and replacement bolts which will work with the one piece top clamp. 2" is as high as you can raise your bars without having to modify your cables. Fitment: Dragon RMK 2009-2010, Pro RMK 2011-2016, RMK Assault 2009-2016, Switchback Assault 2011-2016.
Christina W.
Reviewed in the United States on March 7, 2024
Works as expected
Trudy Deley
Reviewed in Canada on January 15, 2024
Liked.
Justin S.
Reviewed in the United States on November 15, 2023
Very easy install on my 2024 Polaris Rmk Khaos Slash 155. Bolts were plenty long. With low bars already on it, it’s the same height as factory high bars without having to spend hundreds of dollars to swap it out. I wouldn’t run much more than a 2” riser to avoid extending cables as with the 2” riser, cables are stretched but have some play still.
rod o.
Reviewed in the United States on March 16, 2022
Work perfect
zipitypete
Reviewed in the United States on January 17, 2022
I wanted to get a 2 inch rise and these were great. It did not require lengthening the cables. Just right for what i needed.
Ethan Laflamme
Reviewed in Canada on November 4, 2021
So far it’s helped a lot for boondocking. Small amount of ride is perfect for me and it’s held on solid for a whole season.
Breadman
Reviewed in the United States on January 23, 2021
Bolts supplied not long enough. No locking nuts either. Bought some and installed with no issues.
jim
Reviewed in Canada on January 13, 2021
Worked for 96 in the light but the bolts were a half inch too shortStill an excellent product
Eric
Reviewed in the United States on February 2, 2020
Bolts are not the correct kind or even long enough. Should bot have come with allenheads. Yes I did order the correct kit for my machine.
Chris Schulz
Reviewed in the United States on September 9, 2019
2” makes the bars much easier to ise
CHRIS f.
Reviewed in Canada on February 18, 2019
2019 Pro RMK 850. I’m 5 11 and felt the bars were a tad too low. 2 inches made it perfect
Trevor Lanes
Reviewed in the United States on March 25, 2018
2018 Polaris RMK PRO 800 Axys:This fit with out extensions on the cables, but, I had to reroute the stock brake line. Basically it was moved around back of the coolant bottle giving enough slack. Made a mess doing it too because I should have emptied the fluid first. Thought I could move it quickly, but the banjo bolt was not easy to get threaded with the washers on. End results were eventually good!On another note: Last one I bought had poor quality bolts, so I replaced them with grade 8. This one however, came with much higher rated bolts, but I reused the polaris nuts as they were nylon locking and provided ones were not.
Saagar prihar
Reviewed in Canada on April 18, 2016
Good product. Only problem is during my first ride, all 4 nuts came loose and i ended up losing one nut. The nuts included with this don't have built in loctite. Just use your factory nuts and tighten more than the instructions say.
Recommended Products
