Your cart is empty.
Your cart is empty. LED Module Item Parameter
Model Number: P2-32S
Module size: 256mm*128mm
Pixel pitch: 2mm
Pixels Density: 250000 dots/m2
Pixel configuration: 1R1G1B
Package mode: SMD 2IN1 -1515
Pixel resolution: 128dots(W)*64 dots(H)
Max Power: 23W
Module thickness: 13mm
Weight: 0.352KG
Drive type: Constant drive
Scan mode: 1/32scan
Port type: HUB75E
Brightness of white balance: ≥800cd/㎡
Best viewing distance: 2M～30M
Best viewing angle: 140°(W) 120°(H)
Temperature:
storage:-35℃～+65℃
working:-20℃～+60℃
Relative humidity: 10%-95%
Cabinet Thickness: 65mm
Power:
Working voltage: Input 110V-240V, Output AC5V±10%
Average Power consumption: Max.Power consumption: Current: Control system:
CPU: Pentium4 or above P4
Operation system
WIN98/2000/NT/XP/WIN7/WIN10
Control method: Synchronization/Asynchronous
Main technical parameter
Driving device
Constant drive IC
Refresh frequency: >1920HZ
Grey scale/colors: 65536,16.7M
65536gray level/16.7M colors
MTBF: >9000hours
Power switch: Automatic switch
MM
Reviewed in the United States on March 25, 2020
I have bought early versions of these panels from Azerone before they were available on amazon.You can use a single panel with an ESP32 and SmartMatrix, and you can barely use 2 panels with a teensy 3.6 but the refresh rate will be quite poor. Note that they use FM6126A chips, so they do not work out of the box with Smartmatrix as they need a special init sequence.You will most likely want a Raspberry Pi 3 or 4 with rpi-rgb-led-matrix which will support them out of the box, although an active-3 board is recommended for better refresh rates if you use more than 2 panels.The pictures I attached were made with a raspberry pi.The one downside of these panels is that the LEDs are quite small and fragile. A handful can sometimes come off the corners during shipping or if you don't handle them carefully.
Recommended Products
