Your cart is empty.
Your cart is empty.The V2 Lock On System eliminates the need for wire and glue. Utilizing an OE spec throttle tube with a Snap On Cam System, the grip comes molded directly to the plastic tube. Simply replace the grip as you would the entire throttle tube. On the clutch side, the grip is molded to a plastic tube that features a lock jaw clamp to secure the grip to the bars. Simply slide into position and tighten the pre-installed clamp and you are ready to ride. No waiting for glue to dry, no sticky messes and the comfort of knowing that your grips are locked in place and aren’t going to slip off during your ride.
Chris Phipps
Reviewed in the United States on March 7, 2025
Great grips from ODI. Bought as an extra set to keep in the toolbox
kody p.
Reviewed in the United States on February 15, 2025
Best there is
Kenneth S.
Reviewed in the United States on August 20, 2024
Have held up great for 2 months of weekend riding so far and have not slipped once
STEVEN SCOLES
Reviewed in the United States on August 16, 2024
These grips clamp right on and work perfectly. Great grips!
Customer
Reviewed in the United States on June 29, 2024
It’s been quite a while since I’ve changed grips….these things we a snap to install! Definitely ordering these again.
Mike D
Reviewed in the United States on May 19, 2024
Great clamp on grips. I use these for both my T700 and FE350. You'll get about a season of hard enduro or a year of nearly daily use on a street/dualsport. They're comfy so they wear a little quicker.....but they also don't cost 50$ a side like Yamaha wants.FYI some bikes like the T700 have goofy tapered throttle tubes so some sanding may be needed. Ditto for bars that have knurling on the clutch side to hold glue on grips in place.
M. Lanari
Reviewed in Canada on December 1, 2024
The ODI grip is a good product. The ad said it fit my bike. However, the 6-7 included CAMs were not one of them. I looked on ODI’s site and found out, after the fact, which CAM I needed. The product - great, the ad - not so much…
Jerami
Reviewed in the United States on November 10, 2024
Works perfect and fits well. Locks on really well No movement at. Have ridden several hard trails and still holding strong.
Cmazer99
Reviewed in the United States on October 31, 2024
Much easier than glue and wiring on handle grips
AB
Reviewed in Canada on October 4, 2023
I chose these grips because they are a little more soft than my stock ones and I felt they have superior grip in cold or wet conditions. The lock on features great for reusing them if you decide to switch up your bar setup. Overall they’re easy to install feel great and do add a nice look to the setup
Recommended Products
