Your cart is empty.
Your cart is empty. KDSG replacement rubber cap for PVS-14 Night Vision Monocular or PVS-7B/D Night Vision Goggle. The Objective Lens Cap press-fits onto the Objective Lens Housing. It has a small hole in the center to allow enough light in for function-tests during daylight hours without damaging the Image Intensifier Tube. This rubber objective lens cover (daytime training filter, DTF) is compatible with PVS-7, AN/PVS-14, NQ 6015 etc night vision devices (NVDs). Great replacement or back-up accessory for your NVDs.
Tech Specs:
WIDTH ACROSS FLATS - 1.53 INCHES NOMINAL
OPENING INSIDE DIAMETER FOR WHICH DESIGNED - 1.4 INCHES MINIMUM AND 1.42 INCHES MAXIMUM
INSIDE DIAMETER LENGTH - 0.365 INCHES NOMINAL
Shaun
Reviewed in the United States on September 20, 2024
Works
Chris
Reviewed in the United States on January 21, 2024
Fit my pvs14 perfectly.
Robert McEwen
Reviewed in the United States on February 14, 2023
Looks nothing like the picture, defects on the inside and outside.
Customer
Reviewed in the United States on December 21, 2023
nmu
Joe Average
Reviewed in the United States on March 27, 2022
I bought a pair of Gen 3 NVG from ATN. The problem is that the covers they provide are fairly thin and prone to break. I bought this cover for one of the covers that broke. Not only does it fit better but its clearly made thicker and less prone to failure. Overall I can keep protecting the lens with this cover and not worry about it accidentally falling off
Ifly4vamerica
Reviewed in the United States on November 8, 2022
Works great but hey it's just a lense cover. Hard to screw that up. The hole is quite small so needed to open it up a bit for my application.
vulpes vulgaris
Reviewed in the United States on July 8, 2021
Everybody needs a few extra. Use 5.56 brass to make a bigger hole in one to widen the depth of focus.
Recommended Products
