Your cart is empty.
Your cart is empty.Nylon sturdy & stable Wheelie Bar for Arrma 1/8 Kraton EXB ARA8708T1 (Only for EXB V2 Version) - with Rear Bumper
Dave
Reviewed in the United States on February 26, 2025
The media could not be loaded.
GRIDDLE
Reviewed in the United States on July 10, 2024
The media could not be loaded.
jeffrey d.
Reviewed in the United States on June 6, 2024
Works as intended and very sturdy
Infraction8S
Reviewed in the United States on June 28, 2024
Fit was perfect, nicely put together.
NickVB
Reviewed in the United States on June 23, 2024
A must have for the 6s Kraton EXB
Eddy S.
Reviewed in the United States on March 31, 2024
This product worked perfect on my ARRMA Kraton EXB 6S V2. it took me 15 minutes to install. Highly recommend works great.
Tech
Reviewed in the United States on October 18, 2024
Previous review: I wish all parts were made this well, very nicely engineered, but surprisingly heavy because of it. And given that it installs behind the back axle it I'm concerned the weight will actually further it's already being proned to wheelies. Feel like I need to add some front weight now. Make a front bumper just as sturdy and beefy as this and I'm sold, no prob! FYI, this fits perfect BTW but only for Kraton EXB V2 (i.e. after start of 2024).Install instructions are rough but you can figure it out by looking at it. For me it was:1.) Remove wing, make sure nuts stay in wing base.2.) Remove back bumper screws, they will have threadlock on them so expect to use some force.3.) Line up wheelie bar and install 4 screws into top wing base, leave them loose until bottom screws are in.4.) Install bottom screws, you will need to put some locktite on these, get the blue locktite so it's firm but not permanent. If 4 top screws are installed, these along with their included red shims can be fully tightened.Note, the screws you get are different than those in the picture...that's okay.5.) Tighten top 4 screws, but since they are self threading into plastic, don't go for full tight like you can on the bottom two. Go for "quite snug" or else you may strip them out.6.) Put wing back on, hopefully lock-nuts stayed in place otherwise you have to remove the wheelie bar somewhat to put them back. Alternatively you can leave the wing on and just expect a very slow turning with short allen wrenches but it's doable.7.) Done - Enjoy your wheeling.Updated Review:Removed these from my Kraton's. While the parts that are 3D printed have held up, the hardware that holds them to the ride has not (see pic). The two screws that bolt into the rear diff busted off, fortunately left enough stubs I could grab them with vice grips. The 3 of the 4 screws mounting to the wingmount also bent... To be fair, I've done a few cartwheels in my yard with my ride, and have gone off a homemade small jump. But examining the metal I believe there is better hardware out there that needs to not be a weak point for this unit.
Recommended Products
$27.99
$ 14 .99 $14.99
$24.99
$ 12 .99 $12.99