Your cart is empty.
Your cart is empty. Module Features:
1. With optocoupler isolation, the control signal and the power of the controlled device are isolated.
2, High-level start, low-level stop, PWM speed control.
3, Widely used to control the motor start and stop, solenoid valves and other devices.
4, There are 3 specifications MOS tube options: FR120N: 100V 9.4A / LR7843: 30V 161A / AOD4184: 40V 50A.
5. The signal input side can be soldered to the terminal or pin itself, compatible with the breadboard.
6, The output can be welded terminals or direct wire.
7, The module size 23mm X 16mm .There are 2 2mm diameter screw holes, hole spacing 8mm.
Package Included:
2pcs Isolated MOS FET Field Effect Transistor Module
Aaron
Reviewed in the United States on February 9, 2024
One of the 2 boards I received wouldn't work. Glad I tried the other board before thinking that it just wasn't working.
Nick W
Reviewed in the United States on May 28, 2023
Used on a 10A system for ignition switching and couldn’t be happier with it. Small and compact and does what is advertised.
Fuzzhao
Reviewed in the United States on February 11, 2023
The FR120N MOSFET has a pretty high V_GS threshold, if you connect up a load that's under about 7V, the MOSFET won't actually fully switch.The solution is to find the 4.7 kohm pull-down resistor on the gate and replace it with something like 200 kohm. Also, it will never work with a load below 5V.Note: while it specifies that the input voltage range is 3V~5V, the current limiting resistor on the input is about 1 kohm and applying 12V to it resulted in about 10mA of current through the LED. This should be fine for the PC817, which is rated for 50mA maximum at the input, most of the testing done at 20mA
luis torcatt
Reviewed in the United States on May 12, 2021
Excelente
MoonlightTech
Reviewed in the United States on December 15, 2019
Every other version of this has blown in my application but this one is holding. I'm sure all voltage and current ratings are skewed on stuff like this but I can at least say that this one is stronger than the next step lower.
Some Useless Geek
Reviewed in the United States on December 12, 2019
Look up the IR part. It's rated for 161A at 25C -- based on junction temperature, *NOT* package limitation, which is 30A. Even if the package could pass 161 amps continuous -- a physical impossibility -- the resulting power dissipation would be around 85W. That kind of heat would melt that little board down into a puddle.I hate it when these scumbags use numbers that can't possibly work out to advertise their kaka.
Recommended Products
