Your cart is empty.
Your cart is empty.Product Description
Pack of 7/8''(22mm) left handlebar and 1''(24mm) right handlebar
Jacob Gaul
Reviewed in the United States on March 10, 2025
Nice molding, and very comfortable. Slipped right on with some effort and are a challenge to get back off. I didn't have to cut or trim anything for my bar-end mirrors, would definitely buy these again should I need a new set.
elliot
Reviewed in the United States on January 3, 2025
I put these on my mini bike and they fit good. I used isopropyl alcohol to lubricate them to get them to slide on and they fit very snug. Quite comfortable grip
Bobby
Reviewed in the United States on January 23, 2025
Really good quality grips at a great price! I would definitely recommend this to anyone!
T
Reviewed in the United States on September 11, 2024
This product is pretty good and it gets the job done. I have a 1974 cbr 550 and they fit the stock handlebars. The width of the throttle grip fits my custom throttle shaft. The only reason I wouldn't use these are if you tend to go without gear and have sweaty palms because it could slip. The only thing I would change about them is the design of the grip.
T & C
Reviewed in the United States on February 9, 2024
The grips were 2 different sizes. One fit and one was way too loose. It had a much larger inside diameter than the other. They are nice grips though. Well made, good material. I don’t know if the size problem was a mix up from the factory or what. That is the only reason I gave it 4 stars.
Ralph Naraine
Reviewed in the United States on December 30, 2024
The media could not be loaded.
Bryan Murphy
Reviewed in the United States on November 6, 2024
Had to put holes in the ends for my 2016 Kawasaki Vulcan S to fit the bar end weights, but they fit after removing the OEM grips and are much more comfortable!
Calabaza
Reviewed in Mexico on April 4, 2024
No valen el precio.
Benito Sulit
Reviewed in the United States on June 12, 2023
I installed these grips on my bike over the weekend. I have cut out the ends, to accommodate my bar end mirrors. They were real easy to install. With cutting, I think it took me no more than 15 minutes to install. Here’s my secret for years now, I used Elmer’s glue on the bars and inside the grip. They slide in easier! Once dry, they keep the grips in place until it’s time to replace it again. Hope that helps. :)
Recommended Products