Your cart is empty.
Your cart is empty.DescriptionMade from medium carbon steel with hardened jaws. It can hold clutch hubs, flywheels, gears, sprockets, etc. Features 8 millimeter spanner pins. Jaws open up to 5 inches wide. Recommended for square tooth style clutch hubs. Not recommended for v-groove or half round style clutch hubs. Will not work on clutch baskets with reversed inner clutch hubs where the integrated clutch faceplate is facing outward. Replaces HD tool #HD-91042, used on 7984 and later 1340cc models and 1984 and earlier XL models.
Tsang w.
Reviewed in the United States on February 19, 2024
Great value for money, very easy to use, my friends and I are very satisfied.
Kindle Customer
Reviewed in the United States on April 7, 2024
Not real excited about it but got the job done.
James Colton
Reviewed in the United States on December 25, 2022
Used during the restoration of a ‘71 Yamaha Mini Enduro engine and worked perfectly. Should work on just about any motorcycle engine.
t kane
Reviewed in the United States on November 24, 2021
Works great when I needed to torque clutch basket bolt to spec.
Customer
Reviewed in Canada on September 1, 2020
N'ouvre pas assez large pour ma Clutch de drz400 et les dents trop épaisses. Pourtant c'était supposé être ok pour ma clutch.
Eduardo De Jesús
Reviewed in Mexico on February 15, 2020
Facilita tu trabajo
Customer
Reviewed in Canada on October 21, 2020
Does the job no problem
Dennis Lever
Reviewed in Canada on May 22, 2019
worked perfectly.
BRODIE DAVID WURM
Reviewed in Canada on June 15, 2018
Did exactly what i needed it to do!
GunZiLLa
Reviewed in the United States on December 28, 2018
Worked perfect, seems pretty high quality. Came with small decal sticker I'll be putting on my bike. Thanks! Used on Honda F4i clutch basket. Great investment.
Wingin' it
Reviewed in the United States on April 18, 2018
Bought this tool to facilitate Rekluse clutch install in my CRF 450x. Got the job done uneventfully, with no drama, which was exactly what I wanted. Use caution and don't crank up too much pressure on the jaws. It's a holder - prevents clutch from turning while you wreck off the basket nut. Don't try to use it as pliers and it'll work just fine.
beemerguy
Reviewed in the United States on November 12, 2015
Works as advertised. It is a "one size fits all" product so you will need to experiment with different positions on the clutch plate as you tighten the nut. I did not need to lock down the pliers when using it during the clutch install on my bike, but used duct tape to hold the handles in a semi-tight position. Works great once you figure it out. Lots of uTube videos on the net for ease of use.
Sunny in TX
Reviewed in the United States on January 23, 2011
Had to grind out the metal by the rotor holders to get it to fit around the rotor. Otherwise it sat on top and the holders didn't reach the holes. BTW this was for a 2003 Yamaha YZ250F.. Your application may be a little different. Anyway, a bench grinder would be great, I used a 4" angle grinder (probably to heavy duty for a dremel). Once I ground it to fit around the rotor, the pins fit perfectly and it worked great! It was very heavy duty which was good because it took a lot of torque to get the holding nut off. Considering the OEM holder is around $120, my particular mod was easy, it is very heavy duty, and the holder is adjustable, I highly recommend this tool.
Recommended Products
$32.87
$ 16 .99 $16.99