Your cart is empty.
Your cart is empty.The Detonator - unleash the fury of any Kleinn horn with this red flush mount push button switch. The visible part of the button when installed is 1 inches in diameter. The button has screw terminals for easy connection.
Mark
Reviewed in the United States on August 22, 2022
Works perfect!
D. P.
Reviewed in Canada on March 13, 2020
Interrupteur de construction solide et fonctionne très bien.
skamaniac
Reviewed in the United States on February 29, 2020
Used it as a horn button on my boat. Works great!
J Tucker
Reviewed in the United States on September 4, 2018
It is big. You have to drill a 1” hole in your dash to mount it. But the screw terminals on the back provide very positive connections and the button operates well
Comer Williams
Reviewed in the United States on March 29, 2018
The piece was great. I used it for a prop in a short movie I was working on.
Matt Kuipers
Reviewed in the United States on September 16, 2017
Works just fine. Button is not a true red color. Has orange in it. Seems to function as it's supposed to.
Ed SCSC
Reviewed in the United States on April 3, 2017
Works GREAT!! Looks great on my switch post among the others. Easier to reach than the below dash switch I first had installed. Red "target" spot is easy to see and get to when needed. Would recommend and buy again.
CharlieB
Reviewed in the United States on May 18, 2015
Nice sturdy horn button and works as smooth as silk.
Pragmatic
Reviewed in the United States on December 22, 2015
Stout little horn switch. The threads on the barrel, bezel nut, and backing nut are very fine and not all that deep as others have noted. Hopefully they will hold up to years of use. The rear contacts are brass with fine pitch screws to either attach crimp terminal connectors, or alternately place bare twisted wire inside the brass blocks (visible in the product image) and tighten down the clamping screws. The screws on the switch we received were properly tapped/threaded.The momentary switch works as follows, as the button is pushed, a phenolic separator that holds the internal copper contacts apart has a rivet contact on (mid point) it that (when button is depressed) is allowed to contact the copper contacts, thereby actuating the horn (or other attached device). when the horn button is allowed to return to its un-depressed position the copper contacts are again separated by the phenolic separator
Recommended Products
