Your cart is empty.
Your cart is empty.Dennis P
Reviewed in the United States on December 16, 2021
Installation was difficult due to the manufacturer designed wire exit holes. Specifically the poorly designed wire exit holes between the fork and 1st upward curve.The time consuming difficulty was feeding the electronic throttle cable connectors thru the bars past the poorly designed 2nd holes to the fork wire exit.The wire connector had to be cut off and wires spliced to get the wires thru. I learned this the hard way by pulling and pushing the connector thru the first time which resulted in a wire unseating from connector and finding out after reassembly the bike wouldn't start.If I were to do this again I would purchase the HD Batwing Tallboy.Also, It was not necessary to buy extensions for the clutch and brake cables.
Clifton Kapp
Reviewed in the United States on August 27, 2016
Great bars fit and finish. Install was pretty simple even being my first time changing bars. Fit my 2007 Royal Star Tour Deluxe perfect.
Ricky Wilcox
Reviewed in the United States on August 13, 2016
A little more of a job than I thought, but Love them
JB
Reviewed in the United States on March 3, 2016
I did change the oem handlebar of (2012) trike with this one ,my wife loved , no need to extend the wiring or cablesEnded buy a second to replaced a friend's trike as well (2010)No need to replace any factory wires or brake lines in both casesNote :street glide trike (2010)the throttle wire can be use but the small connector will need to be reconnected inside the tube or extend the wires
Customer
Reviewed in the United States on September 27, 2015
Exactly what I wanted for my TriGlide. Finish, fit and value were perfect.
Mike S.
Reviewed in the United States on February 22, 2015
Item as described, arrived quickly.
Michael Matwyuk
Reviewed in the United States on August 31, 2014
I put these on a 2010 Ultra limited to reduce my reach. I am 6' with a 34" sleeve but still felt like I was reaching. These did the trick. They increase the pull back by 2" and raise the handlebars by 2". They sweep back so they look good and add additional control and comfort to the bike. They eliminate the "wheelbarrow" fell of the stock bars. Install was fine, except the throttle by wire routing takes some work. On this bike I needed to get 4" extensions on my clutch and front brake line, and throttle wires as well. So figure in those additional costs as well. Well worth the investment however.
Recommended Products
$380.00
$ 99 .00 $99.00