Your cart is empty.
Your cart is empty. More Choices : The Wire Capacity is MAX.14AWG for 20a Cam Swith with Box, The more bigger size B0CQXTMW7K.B0BRZ45J2Z,B0C7PDMYYY,B0C5Y4XGRZ,B0CG6PYRJ4 is optional .Thank you for your Shopping.
Premium Material
- The Rotary Changeover Switch is made of Flame Retardant Shell,IP 65 grade Stronge Exterior Box.
- The premium Silver Alloy Point, low resistivity, good conductivity, long service life.
- The connecting parts are made of thickened galvanized copper,abrasion resistance and oxidation resistance.
- Stronge screws and Terminals, locking action type,made by high quality, keep safety and durability.
Easy to Operate
- Adjusting handle design with stronge knob, 3 gears can be adjusted.
- Clear panel indication, good sealing and dust-proof performance.
- It's easy to install and disassemble ,easy to operate and control by new operator according to Instruction.
Widely Application
- Circuit control switches
- Test equipment switches
- Motor control switches
- Master control switches
- Signal transfer switches
- Speed switches and other equipment
- Automatic Control
- Machine Tool
- Solar Panel System
- Electrical Motor
- Boat Lift Motor
- Air Compressor
- Generator
- Inverter
- RV and Etc.
Benjamin Sparrow
Reviewed in the United States on May 15, 2024
Nice product 😃
GB
Reviewed in the United States on April 18, 2024
A little light duty. Perfect for my application
Mike C
Reviewed in the United States on September 22, 2023
It's very difficult to get the terminals and wires in the box once they are connected. The box is just a tad too small for the switch and connectors. Some of the wires popped out of the terminals when I tried to button it up and I have a feeling the others will as well.
wugubob
Reviewed in the United States on May 19, 2023
Used this as a battery switcher. Works well so far and is well constructed.
MN4273
Reviewed in the United States on December 24, 2023
They could have given a bit more room to work in, I could barely close it after using #14 wire. Also the terminals are not well marked and I had to use a continuity tester to determine the switch pattern.
Recommended Products