Your cart is empty.
Your cart is empty.For The Kawasaki Krx But It Also Works With Any Other Utv With 2" To 3.0" Shocks Ride Height Or Swapping Coil Springs Our Adjustment Tool Can Be Mounted To Any 3/8" Ratchet. Use It Right Side Up, Upside Down, On Tighten Or Loosen. It Does Not Matter As Long As It Fits! You Can Simply Do Adjustments A Few Clicks At A Time. Designed To Fit Into Tight Places, And We Added Two 3/8" Ratchet Holes To Get The Leverage You Need. Made From Laser Cut 304 Stainless Steel For Long Life.
TC
Reviewed in the United States on February 27, 2025
Solid piece, grips the shock rings like it should.
Mark
Reviewed in the United States on September 30, 2023
I have a Kawasaki KRX 1000 2020. With around 1800 miles on it the tenders we’re starting to sag so I needed to adjust them. I will say the tool looks very very basic. The overall quality of it is fine finish is ok, but I don’t care about that part. It connects to your 3/8 ratchet easily. I adjusted the rears first it has good grip on the adjustment rings and it did take me a couple tries to get the hang of it but once I got it down worked perfectly. It didn’t take much strength to adjust them once started and ready to go maybe about 5 minutes a side. Front shocks I adjusted them on the floor which was awkward as my bench vise didn’t hold the shock well for adjustment. Make sure all the shocks threads are clean and lubricanted and ready, it makes the job easier and tool work as needed. Overall I’m happy I got this over these more expensive wrenches out there as you only use it maybe a couple times.
Recommended Products
$307.95
$ 99 .00 $99.00