Your cart is empty.
Your cart is empty.JR Products is a customer service company providing affordable, quality RV products while maintaining the highest professional and ethical standards.
D. Mc.
Reviewed in the United States on January 15, 2025
Works great as I expected
chris zillig
Reviewed in the United States on August 10, 2024
Replaced my hot water heater switch in a Flagstaff Micro Lite and was exactly like the original.
Single Dad2012
Reviewed in the United States on July 27, 2024
Direct replacement for my defective switch. Quick and easy replacement for my broken RV water heater switch. Works perfectly! Even matched the color.
Samantha Fontaine
Reviewed in Canada on June 2, 2024
Worked perfect and fast shipping
Jaclydlan
Reviewed in the United States on August 13, 2023
Plugged right in and no issues
randy bentley
Reviewed in the United States on December 3, 2023
Worked great
JENNIFER SIMPKINS
Reviewed in the United States on November 27, 2023
Fast delivery. I used this switch to replace my step light switch. Honestly, it was easy to install and actually looks better than the original switch. Perfect fit.
Steve S. Paik
Reviewed in the United States on April 30, 2022
I have a Coachmen Freelander RV that has these switches for the water heater and water pump. I'm creating a new panel and wanted the same switches. These are rated to 10A and light up with 12V to make it easy to indicate when the switches are on.Love these switches, I bought one blue and one red to differentiate between the water pump and water heater.
E. Fisher
Reviewed in the United States on December 4, 2021
I installed this switch to turn on and off my RV WiFi router which is inaccessible otherwise. Yes the rating on the side of the switch says it can handle 120VAC but that might just blow the LED. As you can see in the picture the LED lights when the switch is on.. a nice purdy blue.. Perhaps the other reviewers didn't know how to wire it up? There are only 2 markings on the side... (+) and (-).. the 3rd terminal is unmarked. You must connect +12V to the + terminal, ground/neg to the - terminal and the device's positive wire to the unmarked terminal. The ground/neg for the load/device must also be connected to negative.. I just crimped a spade connector with 2 wires.. one going to the RV negative and one going to the load negative.. slipped this onto the - terminal of the switch, then crimped a spade connector on the single positive wire to the RV positive 12V and a 3rd spade connector to the single positive lead of the load/device. I think it would be very helpful if they'd included a wiring diagram, but I figured it out through trial and error and a multimeter.
Recommended Products
