Your cart is empty.
Your cart is empty.John W.
Reviewed in the United States on July 23, 2024
Unfortunately this propeller was unusable because the round part that slips in between the strut rod and propeller is TOO THICK. The description declared 1/4 inch, but it's at least 3/8 inches. Super frustrating.
Brilliant1
Reviewed in the United States on December 27, 2024
When I ordered this prop puller the add said it would fit prop shafts up to 1 1/8 . Would not fit 1 1/8 shaft so I cut the opening so it would fit . The prop was removed underwater other than it being the wrong size for the shaft it worked good.
Bill
Reviewed in the United States on April 30, 2024
Worked well on 13” bronze wheel. I had to add a little heat on the wheel hub to get it to pop free.
Dan Leonard
Reviewed in the United States on March 26, 2022
Worked great, a must have for the stern drive boat enthusiast.
P. Oregon
Reviewed in the United States on November 9, 2022
First attempt, made sure C Clamp set point was aligned in shaft end dimple.Used 3/4" open end wrench, prop did not release.Removed and rotated position 180deg.Tightened up and C Clamp wouldn't stay in alignment.Clamp Screw alignment nipple sheared off in shaft end dimple.Suggest not this mfg.I contacted the shop that is doing my prop rework and they loaned me a tool, 20 minutes later, Prop in hand.
RAR
Reviewed in the United States on January 13, 2022
Had a prop that was difficult to remove and this held up to the task.
Karie R
Reviewed in the United States on August 29, 2021
Worked good on my tige
Recommended Products