Your cart is empty.
Your cart is empty.Regulator With 140psi Gauge Oiler Lubricator, Oil & Water Separator Unit Air Inlet: 1/4" Max. Pressure of 140psi Temperature Range: 5-60 degrees C (40-140F)
WSBYGD
Reviewed in the United States on April 5, 2021
Easy Install - I have about 12 of these in service.
Tyler backus
Reviewed in the United States on October 1, 2019
Works great and easy to install
David D.
Reviewed in the United States on January 17, 2018
This is ok but its smaller then I though it would be.
Lance
Reviewed in the United States on February 24, 2017
Item arrived on time and was as described. Not the best quality, but it works as it is supposed to.
I am a Geek
Reviewed in the United States on August 3, 2016
Seems to work. I runs my tools at a slightly reduced rate. Cfm is restricted, but not to the point that it is bad. Most tools would work just fine. I am guessing 8cfm. It took 145pis with no issues. regulates to 120 max out
Double D
Reviewed in the United States on November 7, 2016
I purchased this to out in my compressor in my wood shop. Looked good out of the box but that was all it did-look good. I connected it to my compressor and the threads in he gauge leaked like a busted balloon. I used teflon tape and it still leaked. I used something that my dad used to do before teflon tape. Dad would cost the threads with paint and when it dried there would be no leaks. I tried that and it still leaked. I contacted Amazon and got a refund right away and the company told me to just keep the gauge since it did t work. I will try another brand since I need something to keep the moisture out of my air tools.
chandy manivong
Reviewed in the United States on November 26, 2016
Work like it's supposed to
liberty or death
Reviewed in the United States on November 4, 2015
Used for on board air set up on jeep. Doesn't have best pressure but will do the job.
Recommended Products
