Your cart is empty.
Your cart is empty.Product Description
The Diagram of Position for HVAC Blend Door Actuator
AiYiGu branded HVAC heater blend door actuator controls the temperature and climate on your vehicle's air conditioner system. It is a direct replacement for the OEM blend door actuator.
Compatibility
- Compatible with 2002 - 2017 Ford Expedition
- Compatible with 2002 - 2010 Ford Explorer
- Compatible with 2003 - 2005 Lincoln Aviator
- Compatible with 2002 - 2007 Lincoln Navigator
- Compatible with 2002 - 2010 Mercury Mountaineer
Replaces Part Numbers
- 604-213
- 604213
- YH-1743
- 1L2Z19E616BA
- 2L2H19E616AA
Tips
This rear blend door controller had 8 pins terminal connector. There are a couple of similar versions of this parts in the market, you can pull yours out and count the pins to get the correct one. Prior to replacement, you need to make sure this is the exact one you need.
Daniel Ross
Reviewed in the United States on January 14, 2025
Since this blend door actuator , like some of the rest, is an extremely difficult part to access, you would hope to never have to replace it again. I got 2 years and very little use out of this piece of junk! Thanks to aftermarket cr#p, oh and Ford
Kimberly G.
Reviewed in the United States on March 15, 2024
Works great and priced right
odessa
Reviewed in the United States on October 29, 2024
Rear blend door wasn't moving (rear ceiling/floor air flow outlet). Get access by disassembling panels on right side of rear area, unscrew and unplug the old unit, plug in and replace mounting screws to this new actuator, and replace panels. All good. Will see how long it lasts and update if there are any problems.
Leenebee
Reviewed in the United States on October 15, 2024
This is a direct replacement for the OEM part, and it installed as a one for one swap out. It was working just fine after installation, replacing the failed one, and then one day it started clicking. It did stop clicking, and restart a few days later, so I'm not sure what that's about. It should only click if failed. It should not restart and not click. I cannot troubleshoot it down to an action or condition either. It's working just fine right now, but three days ago, clicking. So I guess you take your chances with an aftermarket non-oem part.
Stephanie
Reviewed in Canada on June 12, 2023
Save the hassle and buy the brand name part this one does not work
Tom
Reviewed in the United States on December 6, 2022
Both OEM and this are cheaply made. Might as well buy the cheap one
Angus Cammack
Reviewed in the United States on November 28, 2022
Same as original equipment.
Recommended Products