Your cart is empty.
Your cart is empty.Product Description
Sllane
Reviewed in the United States on May 3, 2024
I have burnt through 3 motors and a spur gear on this prerunner and about 10 spur gears on my sst but this one is handling the abuse of being ran hard. It's seems to be quieter the any of the other that I have purchased
L. Burke
Reviewed in the United States on April 4, 2024
So I'm sure this is a great product, but it certainly isn't "drop in, no other modifications necessary". The stock gearing in the Latrax is 48 Pitch. This spur gear is not 48 Pitch; 48 Pitch is closer to .529 mod.This will sound like holy hell if you're not running a proper .5 MOD Pinion Gear to match your new .5 MOD Spur Gear. Ordered a Robinson Racing 2mm/.5 MOD/14T Pinion gear that'll hopefully pair nicely with this Spur Gear.
Jay Woods
Reviewed in Canada on April 6, 2023
Fits the Latrax teton , shipping was a little slow
Darren Ramsay
Reviewed in Canada on September 18, 2021
My son kept going through spur gears and then we got this one. It’s super beefy and very good quality.
Knot Rocker
Reviewed in the United States on August 9, 2021
At first it made a horrible whining sound. After putting battery and some grease it sounds normal. Maybe even quieter than plastic. It punches great. The power transfer is smooth and it’s just about the same speed. I need to hook up my bearings that will make it faster. I will update. It’s a drop in for my Traxxas Prerunner.
Gnome Ramone
Reviewed in the United States on April 3, 2021
I got this for an old losi mini t 1.0. Fit perfectly, and made the gear noise actually quieter! Just make sure to use some grease.
dakota
Reviewed in the United States on August 1, 2020
The media could not be loaded.
Matthew
Reviewed in the United States on March 22, 2019
Works wonderfully! At first I was thinking it was going to be louder than the factory gear, but I squirt a little grease on it and the buzzing disappeared and it runs perfect!
jackalope
Reviewed in the United States on September 9, 2018
This meshes perfectly with the Traxxas pinion gear and only makes a little bit of extra noise vs the stock plastic gear. I use it in a Latrax Prerunner with a 10 tooth pinion. I recommend adjusting the mesh like this: Remove the little oval metal piece from the motor mount. Loosen both motor screws and roll a folded piece of paper through the spur and pinion while pushing the gears together. Then tighten the screws. I also tried a single layer of paper but it was too tight and there was a lot of noise. Also I lubricate mine with Pedro's Chainj bike lube
Jordan
Reviewed in the United States on December 7, 2018
If you're looking for the solution to your stripped out plastic gear on your Teton/Prerunner/SST, you've come to the right place. This one is quality made and works great.
Recommended Products