Shopping Cart

Your cart is empty.

Your cart is empty.

Hobie Thru Hull 3 Way Plug Kit

Free shipping on orders over $29.99

$32.97

$ 15 .99 $15.99

In Stock
  • Thread wire through the hull of your boat
  • Kit includes 3-way through hull fitting, grommets, o-rings, and instructions
  • Variety of grommets to accommodate different wire sizes
  • Includes grommets to block off the opening


The Hobie 3-Way Thru Hull Wiring Kit - The Hobie 3-Way Thru Hull Wiring Kit allows you to thread wires through the hull of your boat to install fishfinders, GPS and more. The kit contains all of the fittings to run your wires and help ensure minimal leakage and make the installation look clean and professional.


clyde viernes
Reviewed in the United States on December 16, 2024
putting this on the holes of the hobie for battery power and a fish finder was a challenge. none of the inserts fit the wires. hobie needs more insert options.
Joe
Reviewed in the United States on December 21, 2023
So what you see in the photo when purchasing is TWO trees with the grommets for wires to pass through OR block off.WELL plan on spending another 25.00 or more for another tree if the ONE tree they send you doesn’t have a duplicate grommet of what you’re needing. VERY misleading as to what you will receive for 32.00.Not saying it isn’t a product of choice for passing the larger Lowrance plugs through your hull, just plan on being 50.00 deep having to purchase ANOTHER tree for a grommet that should have already been included!
Dat T.
Reviewed in the United States on January 21, 2022
work very good
mark hudson
Reviewed in the United States on December 30, 2021
Exactly as described. Installed easily and works great.
MICHAEL T. BOSTICK
Reviewed in the United States on August 3, 2020
this is exactly what I ordered
Jimmy415
Reviewed in the United States on June 8, 2020
True genuine hobie parts!!
Nosibreh 3
Reviewed in the United States on November 24, 2018
This is a great product to use in the installation of a fish finder in a kayak. You simply drill a hole (1 15/16 I believe) just like the instructions say,run your power and transducer cable to where you want them and then install the plug kit to waterproof the hole. I put a little silicone around mine to ensure it would be waterproof but I don’t think it was needed. The kit comes with plenty of options for your cables. I used one with two holes in the same on but I intend to go back and use one of the two remaining openings for a usb charger.
Mike C
Reviewed in the United States on March 1, 2017
Not as tight as I want it but gets the jobs done
Recommended Products