Your cart is empty.
Your cart is empty. Specification Description:
Model: HA9010H12F-Z
Voltage: DC 12V Current: 0.57A
Speed: 3500RPM
Fan interface to the Graphics card: 4 pin female connector
Cooling Fan Size: approx. 85 mm * 12 mm (Diameter * Height)
Mounting holes distance: approx. 40mm * 40mm * 40mm
The replacement cooling fan is suitable for MSI:
GTX 1050 Hurricane
GTX 1050 Ti Hurricane
GTX 1060 6GT OC
Can work for many other GPU as a DIY fan , but please check the fan size from your own graphic Card.
Joe Mitchell
Reviewed in the United States on April 25, 2024
Same OEM as my NVIDIA GeForce GTX1060 6gb. Exact replacement. If you have a few jewelers Philips Head screw drivers swapping out a noisy/inoperable fan is a breeze.
Jesse Yeager
Reviewed in the United States on March 11, 2022
One of the fans on my 5700 had stopped turning.The 2x 85mm set fit my card perfectly.Installation is tricky, but worth taking the time to get it right.
TheChad
Reviewed in the United States on January 8, 2022
These are very low quality. Installed 2 sets on 2 different gpus. Both had at least 1 fan start to lock up in less than 6 months. Both fans on both sets were completely locked up in 9 months - 1 year. Thats 4 out of 4 fans with less than 1 year life span.
Noadam2003
Reviewed in the United States on July 9, 2021
Does exactly what its supposed to and you can also use it in one fan graphics card if you just disconnect the second fan
Thomas L. West III
Reviewed in the United States on May 1, 2021
I'm not sure about how long the bearings will last, but will report when and if it fails. It fits my PNY GTX 1070 ti which is used for Bitcoin mining and gaming.
Brett Graham
Reviewed in the United States on April 6, 2021
It’s essentially the same size for my 1660ti and everything fit perfectly and then i turned it on. I was extra careful not to bend or mess with anything and as soon as i turned my pc on my fan was blowing at it’s lowest speed and it was the worst grinding noise I’ve ever heard from bearings. I got this because i broke a single blade off one of my double fan 1660ti but since then i sawed off the blade opposite the already broken one as to offset the wobble and shaved it down enough so there’s no noise just 9 out of 11 blades on one fan and it’s still better than what i bought from you.
Gregory James
Reviewed in the United States on June 16, 2019
My PNY XLR8's have 39 mm spacing these fans are 40 mm spacing. I ended up drilling out the holes in both the shroud and fan spokes and used very small zip ties. This worked fine, just a pain to adapt them, I did not measure my spacing first and went by the only review posted. So if you have the PNY XLR8 be sure to check the spacing on your fan shroud before ordering. I am still rating 5 stars because the fans work fine and it was my fault for not checking mine first.
Jeff
Reviewed in the United States on October 29, 2019
These fans fit the PNY GTX 1070 XLR8 (2 fan cooler design, not the red/black 3 fan card). I had to use different screws for 2 of the mounting holes since they did not line up with the shroud, but once installed, cable routing was easy and they work a charm.
Recommended Products
