Your cart is empty.
Your cart is empty.Our aluminum Splash Guards lip fits over the outside edge of the gutter to provide maximum efficiency for water flow into the gutter. Secured in place with 4 screws using the pre-drilled holes.
Lori S
Reviewed in the United States on January 27, 2025
color was great
Daisy
Reviewed in the United States on May 21, 2024
These were a bit more expensive than other brands, but I liked that they are made in the US. Also the design which has the screw mount on the outside of the plate where as other brands have the screw mounts on the inside where the water is. I also found the video explanation/instructions provided helpful.The order comes in a three pack and they are easy to install with an electric drill. In my case, water was spilling over my gutters after I had leaf guards put on top of them. I overlapped two and they have stopped the overflow which was damaging a flower bed below.
Wenzhou
Reviewed in the United States on May 19, 2024
Pretty good product, came complete with everything and installed it with my neighbor:)
MyBluBu
Reviewed in the United States on February 5, 2024
I installed several of these along a 4 foot section of gutter that was prone to water not falling into the gutters during heavy rains. These solved the problem. The color was a good match to my existing gutters.
Customer
Reviewed in the United States on April 17, 2023
works great in the worst of north east storms.
WiscBill
Reviewed in the United States on August 21, 2022
I would give this 10 stars if I could. The product was delivered ahead of the scheduled date by several days. Protected packaging. Excellent heavy gauge. I had a condition that required me to modify the guard turning an outside corner to prevent splashing beyond the end of the gutter. It installed perfectly. I highly recommend this product.
Larkus
Reviewed in the United States on June 2, 2022
Watch the video first. It answers a lot of questions, like, “No, you can’t use a screwdriver.” And “Yes, pre-drill”.I used it with an existing leaf guard. Backed one of the screws from the leaf guard out (and used that for one of the 4 holes on the splash guard installation). Then just use a fine tip sharpie or flare pen to mark the remaining three holes. Pre-drill through both the screen and the gutter. Line things back up - and mount with the screws provided.I opted not to use silicone - overtime, dirt and grime stick to it and you can’t clean it off. Besides, I am looking to stop the blunt waterfall that’s happening where my valley dumps into the gutter. A few drips wont bother me.I think this is a simple and easy to install solution!
DC
Reviewed in the United States on August 2, 2018
Works as intended but they cheaped-out on the screws which require a special wrench to install, why can’t flat or Phillips head screws be provided for such a premim price on this product?
Recommended Products
