Your cart is empty.
Your cart is empty.Product Description
1
GROUND ROD DRIVER HEX SHANK 4/4" Diameter Shank
Ground Rod Driver For Hammer Drills Steel
2
GROUND ROD DRIVER HEX SHANK 1-15/16" Diameter Shank
Ground Rod Driver For Hammer Drills Steel
3
GROUND ROD DRIVER SDS MAX SHANK
Ground Rod Driver For Hammer Drills Steel
4
GROUND ROD DRIVER SDS PLUS SHANK
Ground Rod Driver For Hammer Drills Steel
5
GROUND ROD DRIVER SDS PLUS SHANK MIN
Ground Rod Driver For Hammer Drills Steel
5
MANY MODElS TO CHOOSE
HEX 20MM
HEX 50MM
SDS MAX
SDS PLUS
SDS PLUS (min)
John alzate
Reviewed in the United States on March 14, 2025
Muy cumplido y muy buen repuesto
hector
Reviewed in Mexico on September 25, 2024
Bueno
Aris
Reviewed in the United States on August 2, 2024
It is a bit too shallow and comes out easily from the rod being hammered. However, once you get used to it does the job okay.
M. Adam Davis
Reviewed in the United States on July 13, 2024
This ground rod driver fits as expected and works fine into rocky clay. Beats a sledge hammer any day, and is worth 10x its price in labor costs alone.
Adam S.
Reviewed in the United States on June 22, 2024
This fits my Bosch hammer drill and works well for driving rods. I had no problem driving an 8-inch piece of rebar into the ground to hold pavers in place. I like that it has a recessed area to make holding it onto the rod easier.
Colin G
Reviewed in the United States on October 12, 2024
broke in half first 5 min of driving rod
Rich
Reviewed in the United States on December 29, 2023
diz is my tool and you can't use or touch or look at! Now go away!!!
John Osborne
Reviewed in the United States on November 7, 2023
I picked up this ground rod driver as I had a project to mount and install a new radio antenna and needed a proper grounding rod installed. I have a manual driver for banging poles into the ground but wanted to give this a shot and see how my hammer drill would work.The ground where I needed to install my 8ft rod was wet following the rain and I also turned the hose water on to help loosen the ground more for driving the rod. I don’t have an SDS model as the driver description stated but wanted to see how well my regular hammer drill would work. I was able to start the rod and get it down about 3 feet. It was still going but slowly and my arms were starting to wear out along with my hammer drill battery, so I converted over to my manual driver to finish off the drive.The ground rod driver is very solid and had no issue working the ground rod. It doesn’t show any signs of wear so I believe this would be an amazing way to drive the rod completely if you have the right drill to do it. I’ll borrow a friends drill who has a Hilti meant for this and give it a go on my next rod driving adventure.
jorban
Reviewed in the United States on November 10, 2023
I am always surprised when I like something this simple this much. I don't often drive rods or rebar into the ground, but when I have to, it's never fun... until now. This is so much simpler than a hand-driven rod using a sledge or hammer. I'll be honest, because I only had one rod to drive, I considered just grabbing a hand sledge and devoting 5 minutes to getting it in the soil. Instead, I got out an extension cord and broke open the case for my rotary hammer drill and grabbed this rod driver. he job was done in less than 2 minutes and I wasn't exhausted or breathing heavy. If you have a lot of rods to drive, this is the obvious solution, but I want to also say that if you only have one, this is still the right thing to use! I may not need it again for a long time, but I am never going back to a hand sledge when a solution like this is available to me!
Recommended Products