Shopping Cart

Your cart is empty.

Your cart is empty.

Garage-Pro Aftermarket Engine Splash Shield Compatible with 2010-2015 Toyota Prius and 2012-2018 Prius V Center

Free shipping on orders over $29.99

$34.91

$ 17 .99 $17.99

In Stock
  • Aftermarket Replacement Engine Splash Shield Compatible with 2010-2015 Toyota Prius, Fits 2012-2018 Toyota Prius V, Fits 2012-2015 Toyota Prius Plug-In, Fits 2011-2013 Lexus CT200h
  • Interchange Part Numbers: 5141012105, TO1228169
  • Center Engine Splash Shield
  • Direct Fit Replacement
  • A high quality, Direct Fit OE Replacement Engine Splash Shield, with FREE 1-year UNLIMITED mileage warranty coverage on Garage-Pro items.



Product Description

RK31010013_Hero
Check the location for you Engine Splash Shield
Perfect fit using CAD technology
RBF01750-20108_Tools_Desktop
Auto Parts Giant About

Private
Reviewed in the United States on February 19, 2025
worked out very good on my Car
Tea
Reviewed in the United States on September 10, 2024
It was a perfect fit for our 2013 Prius.
Krish Prasad
Reviewed in the United States on August 18, 2024
Despite a compatibility chart. The product while being inexpensive is not a correct fit for the prius 2011.Also no built in- insulation, thus the car interior is not protected from the heat of the exhaust system.
Ivan F.
Reviewed in the United States on June 11, 2024
This product do not fit for prius 2010, material is not good
Customer
Reviewed in the United States on August 9, 2022
It wasn't super easy to install as some of the holes didn't seem to line up with holes in the chassis. I had to use zip ties to secure the front because of the misalignment.The plastic is fairly thick and looks like it will hold up well as long as it stays secured to the vehicle.
Preacher psych.
Reviewed in the United States on June 19, 2022
It was easy to install and fit perfectly.
Cesar Vargas
Reviewed in the United States on April 3, 2022
good
Michael J. Nguyen
Reviewed in the United States on April 26, 2022
Prompt delivery! I was unhappy with the item because the predrilled holes didn’t aligned with the car chassis; consequently, i had to duct taped one side! Whoever drew the design should review the measurements again! Perhaps the rubber shrunk after fabrication! If so, QA should have caught this issue before mass production!