Your cart is empty.
Your cart is empty.Product Description
- Features: It has heat conducting properties, strong adhesion.
- Suitable for all heatsink without fixed clip.
- Helps disperse the heat from Chipset to heatsink effectively.
- Do not use thermal glue between CPU and HEATSINK.
- The curing rateis related to the relative humidity and temperature in the air, the higher the temperature, the faster the curing speed, and vice versa.
- Recommended coating thickness: 0.1-0.5mm, the thinner the better.
- Please close the lid immediately after use to prevent the glue from curing.
Safety Application
Non-electrical conductive,non-volatile, flame retardant, which eliminates the risk of short circuit and discharges and corrosion damage to the chip and the radiator.
Long-lasting and stable performance
Excellent ease of use and outstanding long-term stability.
Wide working temperature
Wide working temperature: -60℃ ~ 280℃ (-76℉ to 536℉)
Wide range of applications
Use for MOSFET, LED, heat sinks , North-south bridge, graphics card , Printer, Chipset, heat dissipation part, heat dissipation, electrical appliances, instruments and other industries.
Mitch D.
Reviewed in the United States on June 20, 2023
It's hard to have a sense of scale on amazon, and I previously bought much smaller tubes that seem to run out instantly. This thing is a champ and has SO much more usable paste in it. It lasts wayyy longer, and it's a much higher quality too.
SnuSnu
Reviewed in the United States on November 1, 2023
So I was worried about the poor thermal conductivity vs. older discontinued solutions like Arctic Silver. Well, the good news is you can mix this 50/50 with a good thermal paste like Thermal Grizzly and it will still make a permanent bond. I didn't sit there cranking on them to test my luck, but the final adhesion was rock solid.Supposedly mixing with thermal compound is also a solution for people who want good "permanent" adhesion, but is still breakable when removing the heatsinks so that you're not ripping chips off the board. For both that and the much better thermal conductivity, I would highly recommend diluting 50/50 with a good thermal paste as I did. It will definitely hold as good as you could possibly need.
Cesar Pinto
Reviewed in the United States on May 5, 2021
Recommend
Recommended Products