Your cart is empty.
Your cart is empty.
Spec:
- Hardware: V1.0
- Max voltage: 20S (90V，safe for 80V)
- Continuous Current: 80A .
- Max Current: 200A((It is better to increase bigger heat sink)
- Burst current 1000A(theoretical current)
- LED button diameter:12mm
- Size:68mm*34mm*9.5mm(12AWG Wire)
Aluminum pcb Features:
- MOS fets: use 10*10 large package MOS , with better overcurrent and heat dissipation performance
- Control mode: lock key control switch mode; press the lock button to lock it to open, and the LED light will light up at the same time, press the lock button again to bounce it to turn off, and the LED light turn off at the same time.
- The function of the product: the aluminum substrate fire-proof spark switch efficiently and safely protects the power contacts from being burnt and oxidized by the electric spark, effectively protecting the electronic components of the integrated circuit from breakdown and damage, preventing the occurrence of electric sparks that may cause an explosion, and more effectively extending the electronics Product life.
- Aluminum base plate has better heat dissipation performance. It is more convenient to add a larger heat sink for continuous large current output. The heat sink and the heat sink are connected with thermally conductive silicone grease, which has a better heat conduction effect.
JAWs
Reviewed in the United States on June 19, 2024
This is exactly what I was looking for. Something that can switch on and off battery power to a controller without having a spark happen. This can handle up to 90 Volts and 300 Amps, and I am using it with a 72 volt battery system. It's heavy duty wiring is ideal for large connectors. If you wanted to use it with lower power rated systems, you can still use it, but would have to make sure you could use the 10 gauge wire into a connector that could accept that size of the wire. I am using lever connectors that can handle 10 gauge wires.
Matan Raveh
Reviewed in the United States on February 21, 2024
The component itself seems to be working OK.Only problem is, the description is incorrect - it clearly mentions 12AWG (and that's why I bought it), but the cables are actually 10AWG, which was really difficult to use on my XT60 connector.Would expect better description for such an expensive product.
Andrew lattin
Reviewed in the United States on April 16, 2024
Stopped my vecs from being damaged but not my battery didn’t make it to the final build and use of my board but it is what it is
Recommended Products
