Your cart is empty.
Your cart is empty.Replacement Fan Shroud for the Prusa MK3S+ made of Prusament PC-Blend fortified with carbon fiber. This part has a maximum temperature resistance of 130 degrees Celsius, making it an excellent choice for a replacement Fan Shroud.
Alex N
Reviewed in the United States on January 5, 2025
Needed a replacement to print petg prints and only have pla petg to print with so this order came fast and replaced my older melted one.
Mike
Reviewed in the United States on August 21, 2024
Working perfectly. Very high quality print.
ADW
Reviewed in the United States on June 13, 2024
Great replacement, you can see that my OEM one was suffering from heat issues. And since its made from carbon fiber, the printer has 5 more horsepower and can run faster. My wife gives me that special look more often now that its installed, probably because the construction raised my testosterone so far, the printer grew a beard.A+, would buy again.
Logan Schwiderski
Reviewed in the United States on February 20, 2023
I had issues with my fan shroud drooping and eventually entirely melted away when it attached to a print and got sucked into the heater block. This piece is a PERFECT fit and obviously higher quality than the stock mk3s+ printed piece. It's not quite as black as the other pieces but I really don't care about that, the build quality is amazing and this is much more temperature resistant, as it has already survived a print and shows no signs of droop.
Customer
Reviewed in the United States on September 5, 2022
Great and fast customer service. Excellent quality and better than stock prusa mk3s+ fan shroud. Will definitely purchase from them again!
Recommended Products
$33.85
$ 14 .99 $14.99