Your cart is empty.
Your cart is empty.Product Description
Kit Includes:
- 1x Front Left Outer Tie Rod End - ES3473
- 1x Front Lower Right Outer Tie Rod End - ES3472
- 1x Front Upper Right Outer Tie Rod End - ES3474
( Located Between Steering Arm and Pitman Arm )
- 1x Front Inner Tie Rod End (at Pitman Arm) - ES3475
Fitment:
- Replacement for 1999-2004 Jeep Grand Cherokee
Easy Installation
Detroit Axle control arm is designed to be a direct-fit replacement, easy to install, better driving and serviceability.
Premium Alloy
Premium alloy material makes the control arm highly wear-resistant and anti-rust. At the same time, high rigidity can extend the life of the product.
Enhanced Structural-Strength
High-strength structure can withstand repeated impact loads, making it more stable during operation
High Performance
Detroit Axle suspension kit is OE manufactured to meet expectations for fit, form, and function, offering high quality and great value.
808 Central Delaware
Reviewed in the United States on September 15, 2024
FedEx got me again, the whole side of the box was ripped out and a tierod end was missing. I contacted Detroit Axle and they are sending me the missing one.Detroit Axle is the best value going today, and the customer service is excellent. I have Detroit Axle parts on all my vehicles.
Mark s.
Reviewed in the United States on May 5, 2024
They where exact fit , best value for the money
Paul snapp
Reviewed in the United States on December 25, 2024
Fit great, looks like they will do the job.
Dave
Reviewed in the United States on October 8, 2024
Easy installation . Great quality.
Terrence
Reviewed in the United States on February 25, 2023
After a little hard work to remove the old one this product was easy to install and works well
V a N N z
Reviewed in the United States on September 30, 2022
Did not even last 2 weeks. Already ripped even with grease in them. Piece of garbage!!Not sure what happened to this item, I always buy from Detroit Axle with no issues, until now.DO NOT BUY.
IndianaDave
Reviewed in the United States on December 23, 2022
Only thing that would be better is if they were stamped, or marked which position they went in.A word of advice. Do one at a time so you don't get them mixed up.
Nikki Lynn
Reviewed in the United States on November 7, 2021
Good deal but i was missing one set of pins and zerk fittings. The bigger issue it that the threaded portion is about ¾ inch too long on 3 of them (all but the one on the putman arm) so they will bottom out before you can get them all the way in. I just cut the excess off but im not the only one who had this issue so be ready to "make" some stuff fit
Recommended Products