Your cart is empty.
Your cart is empty.Product Description
END MILL MACHINE CHIP REMOVAL FAN
EASY DECONTAMINATION
ALUMINUM SHANK
SCOPE OF APPLICATION
615M&F
Reviewed in the United States on September 29, 2024
Great little chip fan for the money. Spin it up and the fan does all of the work.
Dave
Reviewed in the United States on August 15, 2024
This tool is a fraction of the cost of similar tools. I was nervous about the quality given the low price. The quality is fantastic for the price. The tube it came in says the recommended RPM is 500-1000. This must be a typo of some sort as 1000 RPM doesn’t even open the fan completely. I’m running at 5500 right now and it’s holding together. I’ve been very impressed. It clears away the coolant and chips very well. If you decide to run it faster than the directions on the tube indicate, I suggest starting at 1000 RPM and ramping it up so as to reduce the shock on the blades.
Tmarie
Reviewed in the United States on August 10, 2024
Does a great job at a value price. Regularly run it at 6500 rpm. I start at 1000rpm then ramp up to 6500 in order to limit the initial shock the fan would feel going straight to 6500 rpm. Highly recommend
Carlos B.
Reviewed in the United States on July 18, 2024
Seen this type of tool around , but pricier ! Got one and included it in my process before taping holes on parts and after finishing and it worked great ! Liked it so much I bought a second one for my other machine !
Jc
Reviewed in the United States on November 5, 2024
Great for chip clearing!
Bob ober
Reviewed in the United States on November 14, 2024
The collet is supposed to snap into the cap of the tool holder and then threaded onto the holder, you have the guy putting the collet into the bottom of the tool and then putting the cap on, and that’s just totally wrong, collet snaps into the cap and then put on the bottom and then the tool goes in the collet and you make it tight, just a heads up there the tool will pull out of the holder doing it the way it’s shown in the video. Bighp shows the way!
Marko
Reviewed in Canada on October 10, 2024
Removes chips & coolant fast!
Ethan C
Reviewed in the United States on April 28, 2024
I've been running this fan on one of the CNC machines at work to clear aluminum chips and coolant. It will completely clear a 25"X50" table in about 15 seconds, reducing the amount of cleaning between cycles that my operators have to do(let's be honest, a couple of them spend a little extra time doing it between loading parts to kill time). I was able to virtually eliminate and manual cleaning on the machine I put this on.It doesn't work too well on heavier chips like when I do a lot of face milling on stainless or steel. But it works great for lighter materials like aluminum and plastic.
Donald Coleman
Reviewed in the United States on April 18, 2024
SINCE WE SATRTED USING THIS IN OUR CNC MACHINING. WE HAVE SAVED TIME, WHICH LEADS TO SAVING MONEY. IT ALSO SAVES ON USING SHOP AIR WHICH ADDS UP IN COST SAVINGS.
Recommended Products