Your cart is empty.
Your cart is empty.
CNC Machined
Smooth Anodized Black Finish
Aluminum Housing
Hardened Steel Spool Gears
Full Ball Bearings
Standard 12mm hex
Updated Curved Steering Links
Designed for 1:10 Scale Truck
Front axle size
Total Width: 195mm / 7.68in
Pin to Pin Width: 170mm / 6.69in
Bevel Gear Set: 40T/15T
Gear Ratio:2.67:1
Weight: 198g
Rear axle size
Total Width: 195mm / 7.68in
Pin to Pin Width: 172mm / 6.77in
Bevel Gear Set: 40T/15T
Gear Ratio:2.67:1
Weight: 146g
Johnny Bee
Reviewed in the United States on February 26, 2024
Great replacement for the rc4wd d90!
Aj
Reviewed in the United States on February 14, 2024
I just installed the axle and ran it once n all the teeth broke off of both front and rear piñon I’m not happy about it but just watch out for that n make sure to tighten up every bolt on it if not they will come out within the first few seconds
Jimjo2402
Reviewed in the United States on December 11, 2023
Update:Received a full refund from the seller, so customer support is good.See below for Mt original thoughts on the product.Original review: 1/5The good: on the ousite these are a Very near 1:1 as the RC4WD Yota II axles and will fit without issue.Finish and looks are good!The bad:-my front axle was totaled after just two sessions.-steering angle is very limited at starts to bind up at ~30deg-uses non-CVD linkages in the steering knuckle-internal parts are INCOMPATIBLE with RC4WD/Yota ii.If something breaks that's it! No replacement parts!If you have a TF2 save your money and buy the real thing.
Larry Barnhart
Reviewed in the United States on January 17, 2023
Nice upgrade to hg p407 RC truck!
Recommended Products
