Your cart is empty.
Your cart is empty.NOT FOR POTABLE WATER.MATERIAL - Premium forged brass, thicker and stronger, durable, high corrosion resistance, low magnetic permeability and high temperature ductility. Quantity: 2 pieces brass reducing adapters. SIZE - 1/2 NPT male thread to 1/4 NPT female thread hex bushing. PLEASE NOTE, 1/2 NPT measured value is 0.72~0.83inches, 1/4 NPT measured value is 0.45~0.54inches. Brass pipe reducer is the American NPT standard thread, with 60 degree taper; it's hard connect way and in most cases do not require sealant. FUNCTION - Used to connect female and male pipes with different diameters. Apply to plumbing connections, compressed air, hydraulic, gas and other applications, hex nut for easy tightening and loosening. 1200 psi operating pressure, Temperature range of -65°F to +250°F (-53°C to +121°C). NOTE - Please measure and determine the required size before purchasing, and compare with the size chart. This will ensure you are ordering the exact NPT size for your application requires. These 1/2 to 1/4 npt reducers contain low-lead, NOT FOR POTABLE WATER.
CP
Reviewed in the United States on August 6, 2024
Well made and a good fit for my project.
$kEe-Lo
Reviewed in the United States on August 1, 2024
Used this to put shop air on an air suspension setup. Worked great.
MuttFL
Reviewed in the United States on April 21, 2024
Product as described
FS511
Reviewed in the United States on August 18, 2023
I used these for an air tank mod. No problems
sam simmons
Reviewed in the United States on May 31, 2023
HAD TO RETURN,WRONG FITTING
Steve
Reviewed in the United States on May 14, 2023
Supposed to be 1/2NPT male to 1/4NPt female. Its just a plug. Tried to exchange and got the same garbage.
Customer
Reviewed in the United States on April 7, 2021
Exactly what i was looking for. Working great with no problems so far!!
BG
Reviewed in the United States on November 9, 2020
I found these bushings to NOT be solid brass, nor were they threaded properly.An old hard drive magnet will pick them up easily. As far as I know, brass is not magnetic.Also, they are not taper threaded as pipe fittings should be, so there is little chance of them not leaking if used.Please see the pictures for proof of what I say.I will not buy from this seller ever again.I am tired of substandard products and being lied to.
Recommended Products
