Your cart is empty.
Your cart is empty.For Johnson Evinrude OMC Outboard part number: #0438793, 5030328 (check OEM part number before purchase!!! - Important)
Customer
Reviewed in the United States on February 24, 2025
Only 3 starts because it was not a direct fit. Had to trim some of the rubber from the mounting stud to allow it to seat flush to the motor. Have not used it yet but will update as we progress. Good Price and installation was easy. The metal is good quality.
Gregg C.
Reviewed in Canada on February 16, 2024
They did not provide a screw and old one wouldn’t fit. So was a challenge fiinding one to get a tight fit!
Lazair
Reviewed in the United States on March 3, 2023
Works great, when you unplug fuel line fuel stays in th line.
Allen
Reviewed in the United States on July 27, 2021
works really good
David Elliott
Reviewed in the United States on May 10, 2021
Very Good
tim lam
Reviewed in the United States on October 25, 2021
Fit great on evinrude 6 hp motor
EAB
Reviewed in the United States on July 20, 2020
Worked as is should
scott
Reviewed in the United States on December 7, 2020
Works as it should
Jordan
Reviewed in Australia on November 27, 2020
Fits and works as described
Pookie
Reviewed in Canada on November 16, 2020
Did not fit as stated .. i usually dont write bad reviews but this part wasnt even close to fitting as it stated it would . Leaked and hose didnt fully connect .
ChrisB
Reviewed in Canada on October 5, 2020
I was looking for a replacement for my leaky fuel fitting on my 1991 Johnson outboard. I had searched around the internet and found replacements that seemed quite expensive. When I found this one, it said it was a direct replacement and was reasonably priced. I didn't have my original part handy to compare with the picture (boat was 170 mi north at the family cottage) so I just trusted that it would fit. Well when I tried to install it, it didn't. The first problem was the threads for the mounting bolt are not the same as the original (the new part has metric threads, fortunately I had a bolt in my supplies that fit but it is not stainless like the OEM). The second problem was the mounting point does not fit into the spot for the fitting. That fault was remedied with a coarse file to shape it so it resembles the original. The part body is made of hard plastic and was reshaped fairly easily. The barb on the new fitting is also shorter than OEM so a little creative use of a tie wrap was used to make the fuel line connection. So wile this part was not a direct replacement, it was much more economical than an original part and it did what I needed it to do, stop the fuel leak.
Michael Coca
Reviewed in the United States on April 3, 2020
Great product
Customer
Reviewed in Canada on July 30, 2019
As described and good quality,
Recommended Products
