Your cart is empty.
Your cart is empty.Customer
Reviewed in the United States on September 4, 2024
Exactly as advertised
gamer
Reviewed in the United States on December 4, 2024
BUT IT IS HEAVY
Uncle Wayne
Reviewed in the United States on February 10, 2023
This was a replacement for the pump on a Du-All loader that is on my 1942 Farmall H tractor. It required adapting the fittings for the output hose, but the input was the correct size.
Jim
Reviewed in the United States on January 29, 2023
Works to good. Use this for my 3 point backhoe. I now only idle the engine because the hydraulics work so fast. Also had to adjust my pressure relief valve because I could stall the 32hp diesel engine. The old pump would never do that. It's big and bulky, had to remove my draw bar mount to get it to fit my l3010.
Roy Bronson
Reviewed in the United States on October 6, 2021
I bought this pump to run a log splitter off the back of my tractor. That's what it stays it's made for. Installed the tank plumbed it all out started up tractor stalled it out. Oops got a problem but have no owners manual, no customer service number or anything with the pump.all I know is when I engage the pto it will not spin and can't get an answer why. Will probably return just wanted my log splitter to cycle a faster, this not worth frustration
Lindsey Albaugh
Reviewed in the United States on December 3, 2020
Works as advertised.Used for a 3pt log splitter project, but I added quick disconnects so I can use this as a power unit for other attachments. Pump provides plenty of flow and log splitter has an 8 sec stroke time at half speed (250rpm pto). The pressure is also great and I get 24tons at idle speed. The pump weighs 45-50lbs so I built a hitch receiver mount to use on my JD 1025R. I did not want the weight on the pto shaft.I would buy again. Same specs as a Prince pump for 1/2 the money.
Chad Stephens
Reviewed in the United States on November 20, 2020
I installed this pump on my 560 farmall with a GB hi master 900 loader. I've got about 2 hours of run time on it and it's working well. Quiet operation, moving 1700 lb round bales of hay. It makes enough pressure to overcome the relief valve when I tip the bucket back to the stops and operation is smooth. I protected it will a strainer in the suction side of the tank and a filter in the return to the tank.
Woody
Reviewed in the United States on October 18, 2020
This is one stout pump! I’m fabricating a tow behind log splitter for my New Holland tractor. I didn’t want to use the tractors hydraulic system so I went with a PTO pump. The pump is pretty big so I had to remove the outer PTO shield to be able to install the pump. I then fabricated a torque bracket to provide a stronger counter torque restraint. Pump works fine and I have it on quick disconnect hoses so that I’ll be able to use the pump for other implementations.
Recommended Products