Your cart is empty.
Your cart is empty.
This slipper set is supplied pre-built and ready to install in your vehicle
Features
Precision manufactured aluminum slipper hubs - High strength 57T 0.8 module steel spur gear for maximum power handling capability - Castellated slipper pads for assured location into spur gear - Stainless steel slipper plate - Supplied assembled and set, ready to install into your vehicle
Includes
1 x Assembled Slipper Clutch with Steel Spur Gear
Mike Maher
Reviewed in the United States on June 14, 2023
Garbage
Tim Peck
Reviewed in the United States on May 7, 2023
This is by far the greatest replacement over the stock 3S system. I’ve been running 6S on this with absolutely zero issues!
Jon Haze
Reviewed in the United States on December 11, 2023
I installed this steel slipper set into my Typhon 3S after the factory plastic spur gear got shredded. This is a great upgrade but it definitely feels a little overpriced. If you can get past the cost, it is a great option
Timothy
Reviewed in the United States on March 16, 2022
Not tightened down and no loc tite. Do your maintenance first And secure the bolt and tighten to spec
Paque
Reviewed in Canada on December 3, 2022
Ca fit super bien parfait
S.L.Tooley
Reviewed in the United States on January 28, 2022
This spur gear/slipper clutch was a direct fit in my Arrma Typhon 3s blx. I upgraded the esc to A Hobby Wing 120a esc so I needed this to handle the 4s force. Make sure to grease the gears.
Felty S.
Reviewed in the United States on July 9, 2021
I enjoyed this product the two times that I got to run my car it did real well it loosened itself twice the second time when I pulled it out of the car the whole boat fractured and shot the spring and the bearings and what was left of the bolt into my face be careful where you point that thing once you put it in your truck I feel that it was probably just a manufacturers problem with the bolt itself I think it was fractured ahead of time other than that very happy with the product hoping the company takes care of the mess up from the sheer of that bolt other than that my Arrma was doing 60 miles an hour and it's just a little granite 550 and changed out the motor and the ESC and it's a rocket I really look forward to using my car more in the future and have always been very pleased with the vehicles that Erma makes they're very sturdy but I had to give you a three this time because of the fractured bolt
David Hulsman
Reviewed in the United States on March 23, 2021
Great part for big rock 3s
Bear
Reviewed in the United States on April 13, 2021
Works great on the senton mega 4x4. You will need the AR310881 slipper shaft and maintenance set to install.
Recommended Products
