Your cart is empty.
Your cart is empty.Three piece construction - nut, sleeve and body with attached insert. Use with copper, brass, aluminum, or plastic tubing. -65 Degree F to +250 degree F temperature range. Standard fittings use short nuts. Easy to disassemble no flaring tool required. Primary uses water, gasoline, oil and vacuum lines. 1/2" Tube outer diameter. 3/4"-16 Thread size.
Jeff Timm
Reviewed in the United States on May 20, 2022
I thought I was buying 3 of these? Instead, I received1? It is constructed with 3 pieces...What a RIP-OFF!
Jerry Carter
Reviewed in the United States on February 17, 2021
right price -- work well - make sure to check your sizes
Robert Weatherford
Reviewed in the United States on April 20, 2021
Had no issues
LMS
Reviewed in the United States on June 25, 2017
Perfect for replacing a small run of tubing. This is 1/2" ID like plumbing tubing, not true 1/2" OD tubing.
A. Preiss
Reviewed in the United States on January 13, 2017
Used to get these from Home Chepot, they don't carry them anymore in favor of the Pex tubing. Poor description, this is 1/2 inch internal diameter and too small for use with 1./2 copper pipe which requires 5/8 inch. Had to take a chance, too bad it wasn't what I needed
HydroToxicosis
Reviewed in the United States on April 20, 2017
Everyone kept telling me this would not seal a power steering high pressure line. Here it is 3 weeks on the road and still sealed up.
MrDad
Reviewed in the United States on February 1, 2016
As expected.
DADEMARC
Reviewed in the United States on April 3, 2016
Wish I could find this Item in same size to swap out the union with a Valve ! This worked perfectly to fix crossed water lines if only they had a Compression Valve this size !
Recommended Products
