Your cart is empty.
Your cart is empty.ACCEL 8mm SuperStock Spiral Universal Wire Sets are a true high-performance upgrade from your 7mm OE wires. They feature double-silicone construction around a fiberglass braid; a spiral-wound stainless-steel alloy conductor; and a fiberglass/Kevlar core and can withstand temperatures up to 550 degrees Fahrenheit. The set comes complete with eight extra-long blue wires that have just 500 ohms per foot of resistance for crisper; more efficient ignition; and includes matching blue straight plug boots. They're also available black; red; and classic ACCEL yellow; with either straight or 90-degree boots.
Customer
Reviewed in the United States on November 29, 2017
Not the correct for my vehicle
Carlos Colon
Reviewed in the United States on November 1, 2017
The boots are so big it's impossible to fit them properly on the distributor cap...
John H
Reviewed in Canada on October 18, 2016
Good quality replacement wires I like to create custom length wires and these work well.
Gary H Baker
Reviewed in the United States on April 28, 2015
Love Accel wires they are the best
NHP
Reviewed in the United States on March 14, 2014
If these were set up to have the user crimp and slide the cable through the straight boot I would give 5 stars. having you need to route the wire through the angled boot and pull back through is a friggin pain. Easiest way is lube it stick it in and keep the angle BENT STRAIGHT until you have enough to grab (with pliers) and pull to desired length. pulling back into the angle is not too hard, just watch to make sure your end is lined up for the plug.
zoombabee
Reviewed in the United States on October 29, 2014
Good quality set. Doesn't skimp on extra boots and ends for different distributor setups IE= male/female right angle. Only had to replace my previous set because a couple wires ended up laying up against the exhaust manifold and burned. I saw a lot of complaints about the difficulty putting the ends on. Note* No good set will be easy to do. Here it is, pay attention:1. Use lots of WD402. Use lots of WD403. Feed wire through boot.4 Use lots of WD405. Crimp end on wire.6. Use lots of WD407. Pull wire gently back into boot and install.8. And for those with ADD - use lots of WD40.
Ferric
Reviewed in the United States on September 9, 2013
Installed on my 1995 Ford F-250 7.5L. These things went in smoothly and easily. Cut to fit was very easy to do. Just make sure you have a good set of crimpers.
Jwho?
Reviewed in the United States on May 8, 2011
Custom wires are definately good quality and satisfied with product, but still a little tricky to get the ends on, even with grease. Tip..stretch the cap with a pen like object (I used the back end of an exacto blade holder) and grease the inside thoroughly before attempting to slide on the caps. Also recomend using a crimping tool if you dont have one or misplaced yours like I did. Crimper tabs are challenging to fit in a vise because of their thickness.
A72cutlas
Reviewed in the United States on October 27, 2008
These wires are hot. They allow for hotter plugs, delivering a better spark. And they look good doing it!!;-)
Recommended Products
$67.99
$ 26 .99 $26.99