Your cart is empty.
Your cart is empty.
- This automotive carpet will be made in 501-Black 80/20 Loop. Other colors and materials may be available in the selection above.
- This aftermarket carpet is a replacement for 1955 to 1957 Chevy Bel-Air, 2 and 4 Door Sedan. This is a one piece molded carpet. No Binding on this carpet. Will fit the Wagon passenger area.
- Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
- Unless specified, the jute padding will be attached in the foot area of the carpet
- Installation may require trimming around the edges and the holes may need to be cut.
- There is a large variety of colors available. Please request free samples if you want to match a specific color
- This item fits the years: 1955, 1956, 1957, 55, 56, 57
READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets
1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.
Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.
Yovany Ghersi Martinez
Reviewed in the United States on February 5, 2025
ok
Ally
Reviewed in the United States on May 26, 2024
I installed this carpet in a 55 chevy 210 and it fit poorly around the front tunel area with huge wrinkles. I had to use a clothes iron with steam to shrink it enough to make.it acceptable. The multi piece version should not have this problem.
Henry cubillos
Reviewed in the United States on November 11, 2024
The carpet was ok molded just have to let it sit so it can return to original molded form ! the jute backing was not glued or heated to the carpet it was all loose so i wasnt happy about that its my only complain !
Customer
Reviewed in the United States on June 26, 2023
service was very prompt and very happy with product
Anthony Ronquillo
Reviewed in the United States on December 8, 2023
This was an easy install beautiful carpet, five star quality
Kathy
Reviewed in the United States on July 16, 2020
Great value fast shipping
Scott Whitney
Reviewed in the United States on March 1, 2019
Looks great in my 55 chevy. Easy to install.
Recommended Products
