Shopping Cart

Your cart is empty.

Your cart is empty.

ACC Automotive Carpet Compatible with 1981 to 1987 GMC Standard Cab Pickup Truck, 2 WD 4 Speed (851-Gold Plush Cut Pile)

Free shipping on orders over $29.99

$191.95

$ 75 .99 $75.99

In Stock

1.Color:2000-yellow Neon Cut Pile


  • Carpet will fit just like original carpet when installed correctly and is Guaranteed against Defects
  • Holes may not be cut in carpet and may require trimming to install; Please read Stock Interiors INSTALL INSTRUCTIONS for details
  • Holes may not be cut in auto carpet and carpet may require trimming to install; PLEASE FIND THE INSTALL INSTRUCTIONS ON THE HELP TAB IN OUR STORE DETAILS PAGE
  • Holes may not be cut in carpet and may require trimming to install; Please read Stock Interiors INSTALL INSTRUCTIONS for details


  • This automotive carpet will be made in 851-Gold Plush Cut Pile. Other colors and materials may be available in the selection above.
  • This aftermarket carpet is a replacement for 1981 to 1987 GMC Standard Cab Pickup Truck, 2 WD 4 Speed.
  • Carpet will be made with standard flexibe polyethylene backing. Contact us to upgrade to massbacking
  • Unless specified, the jute padding will be attached in the foot area of the carpet
  • Installation may require trimming around the edges and the holes may need to be cut.
  • There is a large variety of colors available. Please request free samples if you want to match a specific color
  • This item fits the years: 1981, 1982, 1983, 1984, 1985, 1986, 1987, 81, 82, 83, 84, 85, 86, 87

READ FULL INSTRUCTIONS BEFORE BEGINNING - Instructions may vary for multi-piece sets

1. Remove new product from box. Lay flat and pop contours back into place. Allow a few hours for product to relax back into proper shape. Check material for accuracy
2. Compare new and old carpet
3. It may be necessary to use old carpet as a template for console cuts
4. IMPORTANT: Fold new product in half from front to rear. Place in vehicle lining up molded contour to seat risers or any other identifiable starting point on both driver and passenger sides. Once fitted, continue installation
5. Roll product forward make cuts for brackets, shifters vents etc while maintaining proper alignment on seat risers or other starting point
6. Cut in center at firewall to allow product to go underneath dash
7. Continue same procedure for remainder of installation – working your way to outer edges
8. Once product is properly fitted you are now ready to do the final trimmings on outer edges, seat belts and holes etc.

Note: If adhesive is desired, only apply a light brush or spray adhesive after correct dry fit has been obtained.


Kindle Customer
Reviewed in the United States on October 30, 2024
The fit was perfect and made installation easy
kim spiering
Reviewed in the United States on July 14, 2022
not molded right did not fit good
Big Art
Reviewed in the United States on January 6, 2022
The box was damaged and the carpet was torn.
Dan Bray
Reviewed in the United States on June 11, 2020
I ordered the wrong one but it still fit well enough to work and looks great. Nice heavy padding on the back too.
TelesisRacing
Reviewed in the United States on July 8, 2019
Good lookin carpet