Your cart is empty.
Your cart is empty. Brand:new
Material:metal
Color:Black
Size:60X280mm (2.4*11 inch)
Inlet dia.:22mm
Package included:
1XExhaust Pipe Muffler
1X Adapter
1X asbestos gasket
Randy Johnson
Reviewed in the United States on February 11, 2025
Poorly built and obviously done with not a care in the world of proper alignment, the gasket I got when everything is all put together is so lop sided it's sticking out of one side of the silencer and doesn't even align the bolt on tip with the hole Inside properly
Jay S
Reviewed in the United States on January 22, 2025
Quiets it down and sounds sick. Be ready to do some work with it though. Im sure you can clamp it on to the end of your pipe, but I just welded it
Jmach6
Reviewed in the United States on June 21, 2023
No Mounting hardware and the Gasket was broken.
46-Dav
Reviewed in the United States on May 13, 2023
Nice looking muffin 🤤
mark hughes
Reviewed in the United States on October 25, 2022
OK for small engine
R.Jones
Reviewed in the United States on August 7, 2021
I have a 12 foot exhaust extension for my generator that I run under my garage door. This little muffler clamps right on the end and notably quiets the sharp pops. Operating my LOUD 11kw generator like this makes it about as loud as a inverter generator outside the detached garage. And don't worry I have multiple CO detectors and an additional vent fan.
Logan Betts \ Chris C.
Reviewed in the United States on July 9, 2021
It's a decent flow through design, but I did have to cut the end cap off the inlet side to cut back the inlet tube because for some crazy reason it was tapered down to almost 12" inside there before the exhaust reaches the baffle. I also unpacked some glass while I was in there because it seemed a little tight by my standards anyways. I did however give this silencer the benefit of the doubt since I am using it on a 2 stroke motorized bike engine that was heavily modified so it's hard to say if it might have worked just fine on a dirt bike as intended. The tapering thing I don't think is cool for any 2 stroke as the necessary back pressure has already been supplied by the expansion chamber. But again, I didn't use it on a dirt bike, so 4 stars. With a little modification it still was way better than if I had tried to fabricate my own and it looks half decent and the price was very reasonable, especially compared to others of the same type. In the end, even if I'd known I'd have to tweak it, I still would have bought it since now it works perfect and still quiets it down enough to keep the neighbors happy.
Leif Simonitsch
Reviewed in the United States on April 17, 2021
Used a piece of handlebar grip as a coupler to attach this to my motorized bike. Very quiet nice finish. Wish it came with a mounting clamp of some sort.
Recommended Products
$92.99
$ 45 .99 $45.99