Shopping Cart

Your cart is empty.

Your cart is empty.

5V 9V 12V 24V 1 Channel Relay Module with Optocoupler Isolation Support High or Low Level Trigger (9V)

Free shipping on orders over $29.99

$2.00

$ 0 .99 $0.99

In Stock

About this item

  • Module uses genuine high quality relay, normally open interface maximum load: AC 250V / 10A, DC 30V / 10A
  • Using optocoupler chip isolation, strong drive capability, stable performance; trigger current 5mA
  • Module can be set by jumper high or low trigger
  • Fault-tolerant design, even if the control line is broken, the relay will not move
  • The interface design of human nature, all interfaces are available through a direct connection terminal leads, very convenient


Module description:
Module Size: 50mm * 26mm * 18.5mm (L * W * H)
With four fixed bolt holes, holes 3.1mm, spacing 44.5mm * 20.5mm
Power Indicator (green), Relay Status Indicator (red)
Interface:
Input:
VCC: Relay power supply +
GND: Relay power supply -
IN: Signal trigger input (High or Low Level Signal, select via jumper)
Output:
NO: Relay normally open.
COM: Relay Common Pin
NC: Relay normally closed.
Package Included?
1*1 Channel Relay Module With Optocoupler Isolation


Recommended Products