Your cart is empty.
Your cart is empty.
Technical parameters:
Model: YG-50150
Tonnage (tons): 50
Stroke (in): 5.90
Oil capacity (in3): 69.99
A (in): 4.88
B (in): 2.75
C (in): 9.76
Recommended pump: B-700A
Weight (lbs): 42
Robert
Reviewed in the United States on August 2, 2018
No seal kits, but works as well as I can tell.Using for a Lanco filter press where the old hydraulic cylinder died. Seals for that cylinder were $600!!! The new cylinder was a little under $2000! This with a steel bar strong enough for the load replaced it.The handle is an essential on these heavy hydraulic cylinders. Would be nice if it had somewhere to bolt it on to something on the bottom. EZ-Tool said you could weld it to something, but that voids the warranty.I'll update if anything goes wrong. I accidentally loaded a different HYDRAFORE cylinder at about ~2 degree angle and it leaked at 5,000 psi. I've taken better care to keep this one straight.Like the other review mentioned, they don't sell the seals, but for the labor it takes to replace the seals well, if this stays cheap, it's worth it just to buy another. Piston could have pitting, for all you know. It should last years if you use it carefully, as 10,000 psi and 100,000 lbs of force should be used carefully.I've only used it twice as of Aug 2018; I'll update if issues happen.
Tony
Reviewed in the United States on July 11, 2017
Was told prior to purchasing this cylinder that parts are available to repair these cylinders by EZ-Tools USA. Now that I have bad seals and contact EZ-Tools I am told no seal kits are available. Would of made a difference what brand cylinder i purchased. Should be under warranty for a year but after that I guess you can buy another cylinder.
Recommended Products
