Shopping Cart

Your cart is empty.

Your cart is empty.

3' inch Bearing Flush Trim Bit，C3 Carbide Flush Trim Router Bit, 1/2 inch Shank for Wood Router, for DIY, Woodworking Project, High Grade

4.8 (8) Write Review
Free shipping on orders over $29.99

$16.99

$ 7 .99 $7.99

In Stock


Product Description

3" inch Bearing Flush Trim Bit
3" inch Bearing Flush Trim Bit
3" inch Bearing Flush Trim Bit
3" inch Bearing Flush Trim Bit
3" inch Bearing Flush Trim Bit

Warren Clingon
Reviewed in the United States on November 20, 2024
It came with a big chip in the knife,2/16 longUnused
bret frank ashley
Reviewed in the United States on March 6, 2023
I used the bit to router out a sink that was made out of two-inch butcher block. It done just what I needed it to do. Thanks.
irwin langewisch
Reviewed in the United States on February 7, 2023
works well, I am not sure of the longevity. I just received it last week and have only used it once. I like it.
phage1
Reviewed in the United States on September 21, 2022
I made an end grain oak checker table with a resin too and bottom. The edges were a mess so I got this but to clean it up. Wow what a great job! I would put a pic but don’t want to give Amazon access to my pics. Highly recommend this but!
Paragon Concept
Reviewed in the United States on June 20, 2022
I had been looking for a flush trim bit this size for a while now. This is it! Was able to flush trim 2.25" slabs of 3 layer .75" plywood glued together with ease! Plenty sharp and bearing is solid! Totally happy with my purchase! 10/10 would recommend to others!
Debbie Kelly
Reviewed in the United States on November 9, 2022
As SEVERAL OTHERS saying here, this is very defective, used it for one cut and the piece shattered all over the place. Norm Abrams, thanks for reminding about safety goggles. Literally almost put an eye out. Thank heavens he had them on!
Paul Lamb
Reviewed in the United States on November 7, 2022
Worked well and cut with minimal issues
Paul W Morgan
Reviewed in the United States on November 19, 2021
Like many have said on here, the bit itself is a great bit for the money and has held up well, but do yourself a favor and put a new 1/2" bearing on it. Even though many reviews said the bearing was bad, I decided to try for myself and after about 30 seconds of use the top plate came off the bearing and it failed. New bearing on it and it works just fine.