Your cart is empty.
Your cart is empty.Our brew kettle controller designed for up to a 6000 watt element to boil up to 12 - 15 gallons of wort with a reasonable time to boil of about 30 minutes. You will need a 240V, 30 Amp dedicated circuit to run this controller. The controller also powers smaller wattage 240V elements if you have something smaller in mind for your brew pot. Designed to control your rate of boil - no temperature feedback (none needed for boil). Easy to read graduated aluminum face plate - so you can record your boil settings in your notes for your next brew. 12' Power cord with 3 prong dryer plug end. 3 wire twist-lock outlet or dryer outlet with both sides of 240V and safety ground supplied to the outlet. Water resistant all aluminum housing. Full linear control. Low cost compared to other solutions. Controls up to a 240V, 6000 Watt electric heating element. Includes four mounting tabs for mounting on your brew stand or can sit on your counter top. Simple, easy to use design - just plug in and use.
Hayden Oothout
Reviewed in the United States on July 24, 2017
Works great for my Blichmann BoilCoil.
Tom Purdum
Reviewed in the United States on March 6, 2017
Used this three times, then it stopped working. Upon inspection inside, I found the start / stop switch had warped due to excessive heat. It's pretty much junk until I replace the switch.
William
Reviewed in the United States on February 5, 2017
A1
Customer
Reviewed in the United States on January 23, 2017
Works perfectly with the Blichmann Boilcoil. Changing it from the three-prong plug to the four, is pretty simple. Thanks!!
Bill T
Reviewed in the United States on July 12, 2016
Works great with my boil coil! Achieves a boil for 8 gallons of wort in about 20 minutes. Maintains a rolling boil at a setting of about 7.5.No scorching, excellent results. Very happy with this purchase.
RumLove
Reviewed in the United States on November 17, 2016
Works great!
Recommended Products
$194.99
$ 76 .99 $76.99