Your cart is empty.
Your cart is empty.R.K.
Reviewed in the United States on February 9, 2025
Not bad quality for the money. Only issue is it developed a crack at one of the seams. But it's not very visible.
John
Reviewed in the United States on June 11, 2024
Looks just as pictured. Excellent condition. Puts some really awesome sharpness to my Mustang
Krystina Mika
Reviewed in the United States on December 8, 2024
Fit well & holes matched up so no complaints there. But no instructions other than 4 pictures. Comes with screws & tape so that’s a plus. Took a decent while (2-3hrs) to install, but looks great!
jazzercise
Reviewed in the United States on December 26, 2024
Pros: it looks exactly like the pictures.Cons: the sticky stuff comes in a thin ass roll and it kind of sucks at its job- if you don't have a GT, you'll have to drill holes in your trunk (which is whatever, there's a bunch of videos on youtube)- the "instructions" consist of 4 picturesTip: use gift wrapping tape to tape pieces of paper over every area with holes you need (I did 1 on each side and both middles). Poke or draw the holes so you see where they are. Place the spoiler on the trunk, where it sits flush, and transfer the papers to the car using painters or crafting tape. That way, you know exactly where you need to drill holes.Tip #2: use a screw to etch in a little dot. Then a 1/8th drill bit to make the initial holes. Then use a step bit to drill those holes bigger (I did to 7/32nd)
stacy wieg
Reviewed in the United States on December 16, 2024
Extremely great quality, packages very clean and well padded.
Glenda Viera
Reviewed in the United States on November 20, 2024
A gift for my father's car and he installed in less than 20 minutes. His Mustang looks amazing.
Jessica bramblett
Reviewed in the United States on October 7, 2024
They gave the product and the screws and adhesive. I was expecting to do it myself but the instructions was literally a page with 4 pictures on it. No suggested tools to use, how to possibly line up the spoiler easier etc. if you never done it before like me. I’d recommend getting some strong paper to put on the back of the spoiler to mark the holes. Lightly tape the paper on the wing. And then line up the wing to the trunk once it’s even and flush. Make sure the paper is long enough to tape onto the trunk and tape good that way you can pull the wing off the trunk and the paper still be on the trunk with holes marked out. Only way I can think of getting the holes properly marked without messing up the alignment. If I had just a tad bit more info on the spoiler that they could give would’ve gave them 5 starts other than that it’s a good product could suggest getting more or better adhesive as well
M.Welsh
Reviewed in the United States on October 20, 2024
The media could not be loaded.
Recommended Products