Your cart is empty.
Your cart is empty.1/4" (0.25 inch) Flush Mount Black Plastic Body and Sheet Metal Hole Plug - Qty 25
Charlie Davis
Reviewed in the United States on June 3, 2024
Got this specifically to use for guitar pedals for unused ports. Also works if there's jacks on your amp you don't use. Helps you plug into the right jack without looking, and also keeps dust out of them.
Sebastien Lacasse
Reviewed in Canada on December 26, 2024
I bought these for amplifier jack holes and it works perfect!
PayingBetaTester
Reviewed in the United States on December 21, 2024
Just plugs to fill a hole.
Paul E. Guy
Reviewed in the United States on January 14, 2024
Works good. Look better than exposed empty holes.
Amal
Reviewed in Saudi Arabia on August 21, 2023
لم يصلني هذا المنتج ولم ترد لي النقود
Joel Harding
Reviewed in the United States on February 4, 2023
These are perfect for temp plugging of 1/4" trs jacks. Helps keep dust out and prevents wrong plug ins. Would recommend and buy again.
Brian
Reviewed in Canada on January 5, 2023
Fit flush in firewall
Customer
Reviewed in Canada on April 1, 2023
Love it, great price.
Glenn B. Roberts
Reviewed in the United States on August 4, 2022
These little black plugs did exactly what I needed done. Maybe I'm totally loony toons but the two empty screw holes in my car state license plate bugged me. I looked high and low for something to plug them and sure enough these popped on Prime! When I recieved them they seemed too small to possibly work, yet when I popped them easily into the empty holes they fit perfectly and looked good. Problem solved for very little money. Highly recommend!
Wes Asher
Reviewed in the United States on August 25, 2022
I work in HVAC when I drill holes in the ductwork to get measurements for delta T They fit like a glove
Nawbdy
Reviewed in the United States on July 14, 2022
They fit into 1/4" holes in a sheet metal bus floor and their locking shoulder positively engages the edge of the hole. When I take the bus out I'll learn if the flex of going down the road cause them to pop out.
Ryan
Reviewed in Canada on July 30, 2021
Ok Quality + Plug ends have a bulge which helps to keep them in place once the plug is pushed in. Obviously, the hole must be 1/4" for this to work on typical sheet metal.
ElvisG
Reviewed in the United States on September 7, 2020
MADE OF A HARDER PLASTIC, NOT A 15 SECOND SNAP IN, MORE LIKE A 5 MIN + PER UNIT ORDEAL IF YOU ARE LUCKY, AND THEY ARE EASY TO DESTROY WHILE TRYING TO INSTALL. THERE IS LITTLE TO NO GIVE OR CONFORMITY TO THE PRODUCT AS WOULD BE IN A MORE RUBBER BASED HOLE PLUG. ABSOLUTELY NOT A RECOMMENDED BUY AND I'D GIVE IT A TOTALLY WORTHLESS 0 STARS.
Recommended Products
