Your cart is empty.
Your cart is empty.Product Description
Why should we replace the old AC compressor clutch?
The AC compressor serves the purpose of converting the low-pressure refrigerant into a high-pressure refrigerant and sends it to the condenser. It is the central component that maintains the pressure difference between the high-and low-pressure sides of the AC mechanism. Proper lubrication is essential to prevent the compressor from premature wear. A bad compressor, of course, will not send the refrigerant under the required pressure, thereby failing to provide optimal cooling to the vehicle.
How to install?
1. Always wear eye protection.
2. Remove the failed compressor. Transfer any switches, sensors, brackets, or manifolds from the original compressor to the replacement unit.
3. Thoroughly flush each component not being replaced with an approved AC flush solvent.
4. Replace the accumulator or dryer and all expansion devices. including the orifice tube and screen.
5. After installing the replacement compressor on the vehicle ensure proper mounting and belt alignment.
6. It is recommended to install an in-line filter in the suction line near the compressor inlet.
7. Add the proper type and amount of ac oil as per manufacturers procedures.
8. Apply a vacuum to the car ac system. A minimum of 29 inches of mercury for one hour to insure moisture and residual flushing solids or boiled from the system.
9. Recharge your air conditioning system using the recommended Freon.
10. After you finish your repairs, conduct a complete system performance test.
Susan
Reviewed in the United States on September 4, 2020
Was an easy replacement and fit my 06 ram 2500 5.9 as described. Was looking for a possible quick fix, unfortunately my compressor was locked up causing clutch to snap compressor shaft. So now have to order compressor kit and start over.
Darin Aschbrenner
Reviewed in the United States on September 23, 2020
Bearing only lasted for 2 months second rate junk do not buy
clyde miller
Reviewed in the United States on December 27, 2020
It was very hard to install in my Dodge diesel. But no fault of the clutch assembly
Gloucester, VA
Reviewed in the United States on September 28, 2019
PART FAILED IN LESS THAN 600 MILES!
Customer
Reviewed in the United States on August 13, 2019
Didn’t fit my application as described, part looked like good quality though.
Anonymous
Reviewed in the United States on July 20, 2019
Although it is the right part. In usual cheap fashion the power supply wire is to short. Leaving you with a spliced connection under your truck. Plan to reuse the center nut from factory the one supplied is standard grade will break off if you use it to seat the bearing in place.
Twitch
Reviewed in the United States on November 8, 2019
Woulda been perfect if actually fit my truck as stated, but was meant for a diesel engine and I have gas
Rod B.
Reviewed in the United States on November 13, 2019
Worked as advertised. No real issues.
Recommended Products
$39.97
$ 16 .99 $16.99