Your cart is empty.
Your cart is empty.
We are the manufacturer of optical fiber products.
Features
Low insertion loss and high return loss.
High reliability, and save maintenance cost.
Pre-embedded fiber is polished in high quality.
Can be reusable with easy disassembly and assembly.
Can work stably in harsh environment, like severe coldness and dust, high temperature, high humidity, etc.
Few special installation tools required, installation is simple and fast.
low technical requirements for the operators.
Quality Certification
Quality and standards are the foundation of LEITE.
SIA L.
Reviewed in the United States on August 15, 2024
These don’t work, the tools provided are terrible, the cutter does cut, stripping tool is dull and has uneven marks on the blade. The main issue is the cutter doesn’t cut at all. The instructions are written poorly and don’t make clear or concise sense. Seriously, just don’t buy these, you’ll end up frustrated and back to square one only with less optical cable to attach a connector to.
Chris Adams
Reviewed in the United States on December 28, 2024
I was about to come on here and leave a bad review + request a refund BUT on my 7th try, I was able to successfully get a connection. I had to strip my fiber back further than in the video or the pictures show or even the guide on the tool. I would say these are very fragile and should really only be used in a pinch. I had a cable to an outbuilding that made a lot more sense to repair using these than try to replace it.
arthur duncan
Reviewed in the United States on November 14, 2024
ok
Miguel Angel Santana
Reviewed in the United States on November 11, 2024
Calidad precio, buen producto
David
Reviewed in the United States on October 27, 2024
The instructions were a bit unclear, but if you examine the accompanying pictures closely and don't skip any steps you'll do well. Bring a bright light and reading glasses.
LKR
Reviewed in the United States on August 11, 2023
Can’t even say if its good or bad, the problem I had was that I couldn’t fit the coating in the connector.I was trying to fix “monster cable” made cable that get broke by cutting the broken part and setting new connector instead of premade.So, the problem that you can’t insert their cable into this connector, it’s maybe a couple of microns wider but it does not pass “2nd stop” of guiding plastic in the connector.Although I had exactly the same issue with connector of other maker , so I guess its more problem of monster cable being less standard , but still be aware that you can have this issue - this connector does not work with all cables around.Well , at least the cup fits 😉 on other maker I had a cup with hole not 0.9 but 125 micron, so had to strip extra inch+ of outer jacket in order to put it on cable and it made it also less reliable
gurutech
Reviewed in the United States on June 14, 2023
I was not expecting allot considering the price point and I was pleasantly surprised. I used these successfully on a 300 foot run of 50/125 OM4 multimode fiber. I achieved low insertion loss and decent light pattern. The fiber could also be released and reworked if your first attempt is not successful. Proper prep is very important as usual.
Customer
Reviewed in the United States on December 11, 2023
I didn't have any issue with getting it to work, I did see some insertion loss, but it was less than 1 dbm and not a problem. I used the cleaver it came with, and my own strippers.The only downside, is that it only secures the 900um tight buffer of the fiber, not the 2 or 3mm outer jacket. It would have been a relatively simple matter to design this such that the outer jacket is captured and cinched down.The end result is rather delicate and should be contained in an enclosure, and not directly use it in a patch panel or the back of a server. Certainly one doesn't have to use an enclosure, but it's risky as exposed 900um buffer is usually protected against physical bumping.
Recommended Products
