Your cart is empty.
Your cart is empty.Product Description
This 12-Inch diameter 220 grit aluminum oxide sanding disc is sized to fit most common disc sanders and is sold in a 2 pack. This sanding disc is pre-applied with top-quality pressure sensitive adhesive.
From the Manufacturer
Sized to fit most common disc sanders from hand-held orbitals to hefty shop sanders. This aluminum oxide disc is pre-applied with top-quality pressure sensitive adhesive.
Mister B
Reviewed in Canada on July 26, 2024
For some reason I had a hard time finding 220 grit in a 12" disc, found these ones on Amazon.Still on my first one.Use for sharpening my joiner and planer blades, gives them a very shape edge.
Robert S. Setterberg
Reviewed in the United States on September 5, 2020
I liked them worked great and good service from Amazon
Customer
Reviewed in the United States on March 17, 2017
these are the worst sanding pads I have purchased. The adhesive was dry and did not stick to the sander. I would not recommend this product to anyone
robert fricks
Reviewed in the United States on February 7, 2016
well made
texas effect
Reviewed in the United States on January 21, 2016
Great product for what I needed. Work with wood and these are top shelf discs. I will buy again when I need 12" media.
I.B. Miller
Reviewed in the United States on August 12, 2014
Very high quality and durable - lasts a shockingly long amount of time between changes
AKF
Reviewed in the United States on October 10, 2014
These pads are excellent. They have only been used for sharpening lathe chisels so far but they have maintained their grit after numerous sharpening. They stick well and come off without issue. Will buy again.
Dejure
Reviewed in the United States on July 6, 2013
I've only used two of these so far. The first tore apart moments after installation, but it's possible I didn't notice a slight air gap under a portion of it during installation, which would have caught on the edge of the board I was rounding over.The second disk has been working just fine for some time and shows signs of having a reasonable life span. Of course, how long it provides good service will be dependent on if I continue to take time to clean it, when needed. For that, I use and recommend investing in the long rubber "eraser," which is designed for that purpose.That the second disk is still doing well supports the probability of operator error during installation being the cause of failure for the the first one. Of course, defect shouldn't be ruled out yet.Both disks ran or run on a Powermatic sander. It's a pretty serious sander, especially compared to the little Hitachi I used to have, so disks and belts have to be high quality to hold up.I'll try to update this report after time allows for a bit more experience with the disk.
john k phillips
Reviewed in the United States on March 14, 2013
Haved used several times and have been completely happy with the results. Would like a finer grit but have not found any yet.
Recommended Products
$9.95
$ 4 .99 $4.99