Your cart is empty.
Your cart is empty.
Waverly Ebony Bridge Pins
Hand-turned, vintage style. High quality, precisely machined with no mold lines.
All pins have a 5-degree taper on a 1"-long (25.40mm) shaft, decreasing in diameter from approximately .262" (6.65mm) under the collar to .172" (4.37mm) at the bottom of the pin (See Second Image for the full list of measurements)
Oversized pins are thicker for worn bridge pin holes. Available with or without inlaid dot. Sold in packages of 6. Jewelry for your guitar A vintage material is reborn Our ebony bridge pins, endpins and strap buttons are made of Galalith, a dense and durable casein-based material that polishes beautifully. Popular in the early 20th century, Galalith is found today in collectible vintage jewelry. It cannot be molded; each pin is precisely machined and has none of the unsightly mold lines common to plastic pins.
Our ebony pins match our endpins and the knobs on Waverly guitar tuners.
SPECS:
- Overall length: 1.25" (31.75mm)
- Widest diameter (above collar): .320" (8.13mm)
- Shaft length: 1" (25.40mm)
- Shaft taper: 5-degree taper
- Shaft diameter just under collar: .262" (6.65mm)
- Shaft diameter at bottom of pin: .172" (4.37mm)
- String slot width: .070" (1.79mm)
Macstilton
Reviewed in the United States on September 21, 2023
Had to make them smaller (not something I’m use to doing)
Terry Primm
Reviewed in the United States on August 9, 2021
The pins were too large
Dick. J
Reviewed in the United States on June 11, 2021
Bought these to put in my Blueridge that had loose pins and was excited to get them but was very disappointed to discover they were WAY too large to fit into a standard bridge. I just threw them away as they weren't worth returning.
Terry Williams
Reviewed in the United States on March 8, 2021
Good quality
Mike from WNY
Reviewed in the United States on April 4, 2020
I needed these pins because I used a reamer with an incorrect taper on a guitar build and the pin holes are too large now. These pins are quite a bit oversized and so I will have to carefully sand each one to fit. Tedious but not the pin's fault. They arrived quickly so I am able to carry on with this build.
Daniel Palmer
Reviewed in the United States on July 21, 2019
Product is high quality and works exactly as stated. If you wish to drop to light strings, i.e., 10 - 48, these pins will work beautifully.
Leah C. Houpt
Reviewed in the United States on June 20, 2019
Waverly inadvertently included one regular size pin with five oversized pins. I'm still giving a 5-star rating, because it was the fault of the manufacturer, not the distributor, Stewmac. I called the Stewmac customer service rep, who offered to replace the pin and expedite the shipping. The bridge pin quality is very good.
LidoBob
Reviewed in the United States on August 23, 2017
The bridge pin holes in my old Guild F50 had enlarged over the years and these were the perfect solution. Fit is now snug, duct tape on old pins is gone (1) and pure tone restored. Very happy with the product and excited to find them available, as Guitar Center does not carry any similar product.
Recommended Products
